摘要
采用有限元数值模拟仿真技术研究液力挤压过程中模具定径尺寸,并与实测结果相比较。结果表明:数值模拟仿真计算结果和实测结果相一致,即随着挤压比的增大,制品直径回弹量也随之增大;当制品直径尺寸精度要求大于5道时,模具设计中定径尺寸的回弹量可忽略。
The finite element numerical simulation technique was used to study the mould sizing dimension in the process of hydraulic extrusion, and the calculated results were compared with that of experimental results. The results show that the numerical simulated values are identical with experimental values. The springback values increase with the increase of extrusion ratio. The springback values of sizing dimension in die design can be disregarded if diameter dimensional accuracy of products is more than 0.01 mm.
出处
《兵器材料科学与工程》
CAS
CSCD
北大核心
2013年第5期97-99,共3页
Ordnance Material Science and Engineering
关键词
液力挤压
定径尺寸
数值仿真
hydraulic extrusion
sizing dimension
numerical simulation
