基于ARM的嵌入式打孔机系统研究

The Design of Embedded Positioning Punching Machine Based on ARM

本文介绍了一种基于ARM的嵌入式打孔机系统的设计方案,该方案采用ARM11作为主控芯片,对模拟CCD进行图像采集,然后通过图像算法进行圆心定位,最后驱动步进电机进行定位与冲孔。经过现场整机测试,该机的各项性能指标均达到了预期设计目标。

This paper describes an embedded positioning punching system which is based on ARM. This system used $3S6410 as the master chip for acquisition and processing the CCD image, adopted the image algorithm to seek out the center location, and drove the Stepping motor for positioning and punching. After testing, the performance of this system can perfectly achieve the aim.