期刊文献+

一种新型三电平直流变换器的仿真研究 被引量:1

Research on Simulation of a New Three-Level DC-DC Converter
下载PDF
导出
摘要 文章提出了一种新型的隔离式三电平直流变换器的拓扑,它是在传统的两电平变换器的基础上提出来的。在这种新型拓扑中,每个开关管的电压应力都比两电平时降低了一半,并且滤波器的体积也明显减小,使其更适用于高电压大功率场合,且拓扑极具对称性,这样方便了工作原理的分析及控制电路的设计。文章以SEPIC三电平直流变换器为例,分析了该变换器的工作原理,给出了控制策略。通过仿真结果,验证了工作原理和控制策略的正确性,比如电压应力低等特点。 This paper proposes a new isolated Three-Level DC-DC converter.The isolated SEPIC TL DC-DC converter is based on the conventional SEPIC converter.In this new converter the voltage stress of the switch is reduced to a half and the filter inductor is also significantly reduced.Its operation principle and control strategies of the converter are investigated.By modeling and simulation,the performances of the DC-DC converter and control strategies have been verified,such as low switch voltage stress and so on.
出处 《工业控制计算机》 2013年第10期144-146,共3页 Industrial Control Computer
关键词 隔离式直流变换器 SEPIC 三电平 电容均压 lsolated DC-DC converter,SEPIC,TL DC converter,Capacitors" voltage balancing
  • 相关文献

参考文献6

  • 1J.R.Pinheiro and I.Barbi,The three-level ZVS PWM converter-A new concept in high-voltage DC-to-DC conversion,in Proc.IEEE IECON,1992,pp.173-178.
  • 2J.R.Pinheiro and I.Barbi,Wide load range three-level ZVS-PWM DC-to-DC converter,in Proc.IEEE Power Electron.Spec.Conf.,1993,pp.171-177.
  • 3R.Ayyanar and N.Mohan,Novel soft-switching DC-DC converter with full ZVS-range and reduced filter requirement Part Ⅰ:Regulated-output applications,IEEE Trans.Power Electron.,Volo 16,no.2,pp.184-192,Mar.2001.
  • 4Ruan Xin-bo.Three-Level DC/DC Converter and SoftSwitching Technique.Beijing:published by Science Publishing Company,2006,12.
  • 5张伟,张东来,罗勇,卢柱强.推挽电路中变压器偏磁机理及抑制方法的研究[J].电力电子技术,2006,40(5):101-103. 被引量:12
  • 6Wu Chen,Xinbo Ruan,Hong Yan,and Chi K.Tse.DC/DC Conversion Systems Consisting of Multiple Converter Modules:Stability,Control,and Experimental Verifications[J].IEEE Transactions on Power Electronics,2009,24(6):1463-1474.

二级参考文献2

共引文献11

同被引文献2

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部