摘要
电子回旋共振(ECR)质子源产生的脉冲质子束脉宽通常在ms或亚ms量级,高梯度加速结构要求注入的质子束脉宽为100ns或更短,需要一个脉冲踢束器将大部分不需要的束流踢开,留下所需的短脉冲质子束。设计的踢束器采用静电偏转方法,针对在研ECR质子源的束流参数,设计了脉冲踢束器的结构尺寸,使用ANSYS软件计算了踢束器的静电场分布情况,利用软件内置的CMATRIX宏提取了结构电容的数据,给出了对脉冲踢束电源的参数要求,讨论了踢束脉冲上升沿和产生的束流脉冲上升沿的对应关系。
The shortest pulse width of ECR proton source is about sub-millisecond. A chopper or a kicker is important to produce 100 ns pulsed proton beams for high gradient accelerating structure. Physical design of an electrostatic kicker is described in this paper. The configuration of the kicker is matched with an ECR proton source which is being investigated. Electrostatic field is calculated with ANSYS. The capacitance of the kicker is extracted with CMATRIX command macro. Relations between beam＇s rising time and kicker pulse＇s rising time are discussed. The desire for pulsed power supply is also analyzed.
出处
《强激光与粒子束》
EI
CAS
CSCD
北大核心
2013年第11期2999-3003,共5页
High Power Laser and Particle Beams
基金
国家自然科学基金重点项目(11035004)
中国工程物理研究院科学技术发展基金重点项目(2013A0402018)
关键词
脉冲踢束器
质子源
静电场计算
电容计算
脉冲电源
pulsed kicker
proton source
electrostatic field calculation
capacitance calculation
pulsed power supply
