期刊文献+

中隔墩对大型泵站进水流道水力性能的影响 被引量:4

Influence of Middle Division Pier on the Hydraulic Performance for Inlet Conduit of a Large-scale Pumping Station
下载PDF
导出
摘要 运用数值计算和模型试验相结合的方法,研究了在进水流道进口水流方向偏斜时,中隔墩对进水流道水力损失及流道出口断面的水流均匀度、水流入泵平均角度的影响,并对影响机理进行了初步分析。研究结果表明:在进水流道中设置中隔墩对进水流道的流态影响较小,设计流量时的流道水力损失增加约0.005m;当前池存在横向流速时,中隔墩对改善进水流道内的流态是有利的;进水流道水力损失的增加主要是由于隔墩的存在减小了过流面积,使得水流流速增加所引起的。数值计算和模型试验的结果基本一致。 The combination method of numerical calculation and model test was applied to investigate the effects of middle division pier on the hydraulic loss and flow uniformity and average flow entrance angle at the outlet conduit when the inflow direction was oblique at the elbow inlet conduit. The influence mechanism was analyzed preliminarily. The research results indicated that (1) the influence of the middle division pier on the flow pattern at the elbow inlet conduit is insignificant with an increasing of hydraulic loss of about 0.005 m under the design discharge; (2) when transverse velocity exists in the forebay, the middle division pier is beneficial to improve the flow pattern at the inlet conduit; and (3) the increasing of hydraulic loss at the inlet conduit is mainly due to the increasing of flow velocity caused by the reduction of flow area. The results obtained from the numerical simulation method were consistent with those determined by the model test method.
出处 《南水北调与水利科技》 CAS CSCD 北大核心 2013年第6期102-105,共4页 South-to-North Water Transfers and Water Science & Technology
基金 江苏省重点实验室开放基金(057387003K12022)
关键词 数值计算 模型试验 中隔墩 进水流道 水力性能 numerical calculation model test middle division pier inlet conduit hydraulic performance
  • 相关文献

参考文献12

  • 1谢伟东,汤正军,陆林广,吴开平,冷豫.江都三站进水流道优化数值计算及模型试验研究[J].南水北调与水利科技,2005,3(3):38-40. 被引量:4
  • 2刘军,邓东升,马志华,顾美娟,陆林广,祝捷.宝应泵站流道优化计算与模型试验研究[J].南水北调与水利科技,2005,3(2):22-25. 被引量:14
  • 3马福喜,王金瑞.三维水流数值模拟[J].水利学报,1996,28(8):39-44. 被引量:17
  • 4金忠青.N-S方程的数值解及紊流模型[M].南京:河海大学出版社,1988:11-66.
  • 5Lakehal. D, Theodoridis. G. S, Rodi. W. Three-Dimensional Flow and Heat Transfer Calculations of Film Cooling at the Leading Edge of a Symmetrical Turbine Blade Model[J]. Inter national Journal of Heat and Fluid Flow, 2001, (22):113-122.
  • 6Blazek J. Computational Fluid Dynamics: Principles and Appli- cations(Second Edition) rMJ. Oxford: Elsevier Ltd. , 2005 : 271- 302.
  • 7Muggii. F. A, Eisele. K, Casey. M. V. Flow Analysis in a Pump Diffuser-Part 2: Validation and Limitations of CFD for Diffuser Flows[J]. Journal of Hydraulic Engineering, 1997, (12): 978-984.
  • 8Muggli. F. A. , Holbein. P. CFD Calculation of a Mixed Flow Pump Characteristic From Shutoff to Maximum Flow [J]. Journal of Fluids Engineering, 2002, (9) : 798-802.
  • 9Constantinescu. G. S, Patel. V. C. Numerical Model for Simu lation of Pump-Intake Flow and Vortices[J]. Journal of Hy- draulic Engineering,2007, (2) : 123- 134.
  • 10Rodi W. Turbulence Models and Their Application in Hydrau- lics Experimental and Mathematical Fluid Dynamics [M]. Delft:IAHR Section on Fundamentals of Division 11,1980: 44-46.

二级参考文献7

  • 1Song C C S,International power generation conference,1991年
  • 2张长高,河海大学学报,1994年
  • 3张兰丁,1991年
  • 4梁曾相,水利学报,1991年,9期
  • 5周力行,湍流两相流动与燃烧的数值模拟,1991年
  • 6马吉明,博士学位论文,1988年
  • 7匿名著者,1986年

共引文献80

同被引文献46

引证文献4

二级引证文献24

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部