摘要
An Al2O3-TiB2 nanocomposite was successfully synthesized by ball milling of Al, TiO2 and two B source materials of B2O3 （system （1）） and H3BO3 （system （2））. Phase identification of the milled samples was examined by Xray diffraction. The morphology and microstructure of the milled powders were monitored by scanning electron microscopy and transmission electron microscopy. It was found that the formation of this composite was completed after 15 and 30 h of milling time in systems （1） and （2）, respectively. More milling energy was required for the formation of this composite in system （2） due to the lubricant properties of HaBO3 and also its decomposition to HBO2 and B2O3 during milling. On the basis of X-ray diffraction patterns and thermodynamic calculations, this composite was formed by highly exothermic mechanically induced self-sustaining reactions （MSR） in both systems. The MSR mode took place around 9 h and 25 h of milling in systems （1） and （2）, respectively. At the end of milling （15 h for system （1） and 30 h for system （2）） the grain size of about 35-50 nm was obtained in both systems.
An Al2O3-TiB2 nanocomposite was successfully synthesized by ball milling of Al, TiO2 and two B source materials of B2O3 （system （1）） and H3BO3 （system （2））. Phase identification of the milled samples was examined by Xray diffraction. The morphology and microstructure of the milled powders were monitored by scanning electron microscopy and transmission electron microscopy. It was found that the formation of this composite was completed after 15 and 30 h of milling time in systems （1） and （2）, respectively. More milling energy was required for the formation of this composite in system （2） due to the lubricant properties of HaBO3 and also its decomposition to HBO2 and B2O3 during milling. On the basis of X-ray diffraction patterns and thermodynamic calculations, this composite was formed by highly exothermic mechanically induced self-sustaining reactions （MSR） in both systems. The MSR mode took place around 9 h and 25 h of milling in systems （1） and （2）, respectively. At the end of milling （15 h for system （1） and 30 h for system （2）） the grain size of about 35-50 nm was obtained in both systems.
