摘要
使用Polyflow软件模拟了特定条件下熔体在螺杆柱塞式注射单元中的流动状态。模拟结果显示,在最大注射速度下,熔体流经喷嘴时的压力损失很大;熔体在最高注射压力下流动时,随着模腔压力的增大,注射速度逐渐减小,但熔体流经喷嘴时,速度骤增。
Flow state of melt in injection units of screw-plunger injection molding machines under specific conditions was simulated. Simulation results show that under the maximum injection speed, the nozzle pressure loss is great; under the maximum injection pressure, the injection speed decreases by degrees with the increase of cavity pressure, and the speed has a fierce increase when the melt flows through the nozzle.
出处
《中国塑料》
CAS
CSCD
北大核心
2013年第12期94-97,共4页
China Plastics
基金
北京市大学生科学研究与创业行动计划项目(SJ201302002)
北京工商大学青年教师科研启动基金(QNJJ2011-32)
关键词
螺杆柱塞式注塑机
注射单元
数值模拟
screw-plunger injection molding machine
injection unit
numerical simulation