摘要
二步法旋压机包含翻边机、压鼓机。通常封头厂希望翻边机(在设备规格确定的条件下)能加工厚的封头,同时要求加工封头最小直径,这二者之间很多时候是矛盾的,所以如何配置的上夹紧油缸外径最小,是加工封头最小直径的关键。
Two step spinning machine consists of flanging machine, pressure drum machine. Usually end socket factory hopes flanging machine can processing thick end socket, at the same time asks for minimum diameter, a lot of the time, the two is contradictory, so how to configure the minimum diameter of clamping cylinder is the key of processing the minimum diameter of end socket.
出处
《价值工程》
2014年第4期50-51,共2页
Value Engineering
关键词
旋压机
二步法旋压机
上夹紧油缸弯曲分析
spinning machine
two step spinning machine
the bending analysis of upper grip cylinder
