期刊文献+

鲜胶乳凝聚法制备粉末天然橡胶及其性能研究 被引量:1

Preparation and Properties of Powdered Natural Rubber by Coagulation from Fresh Latex
下载PDF
导出
摘要 采用凝聚法,以鲜胶乳为原料制备粉末天然橡胶(PNR),研究了胶乳凝聚影响因素、产品粒径分布和产品干燥条件,并测试了其性能。结果表明,胶乳的pH值为9.3.9.4,硫酸铝用量为3.70%。3.77%为宜,胶乳浓度对产品收率影响不大;隔离剂纳米二氧化硅的用量在2-3份为宜,产品粒径处于1.0-4.0mm的比例在83%以上。与酸凝天然橡胶相比,制备的PNR的灰分含量、氮含量、挥发物含量、Po和PRI都较高.丙酮溶物含量和门尼粘度较低;PNR混炼胶的Mmin较小,△t30相差不大;PNR混炼胶的ML和VM较小,t10和t90较大,硫化速率较慢;PNR硫化胶的拉伸强度、300%定伸应力和500%定伸应力较高.扯断伸长率较低. Powered natural rubber (PNR) was prepared by coagulation from fresh latex and the effects on coagulation, size particle and drying process conditions were investigated. The results showed that the optimal conditions were: pH of fresh latex was 9.3-9.4, the quantity of coagulant was 3.70%-3.77% and the dosage of isolating agent was 2-3. Concentration of fresh latex had little influence on the yield of PNR and the portion of PNR with particle size distribution of 1.0-4.0 mm was higher than 83%. Ash content, nitrogen content, Po and PRI of PNR were all higher than that of acid coagulated natural rubber, while Mooney Viscosity, impurity content and acetone soluble content were lower. The rubber compound of PNR had better flowability, lower ML, higer Mn and a slower curing rate. After being vulcanized, the tensile strength and 300% stretching stress of PNR were larger than that of NR-a, while its elongation at break was smaller.
出处 《热带作物学报》 CSCD 北大核心 2014年第2期375-380,共6页 Chinese Journal of Tropical Crops
基金 云南省自然科学基金项目(No.2012FD086)
关键词 粉末天然橡胶 鲜胶乳 凝聚 性能 Powdered natural rubber Fresh latex Coagulation Property
  • 相关文献

参考文献16

  • 1Widmer H,Milner P W. Powdered rubber[J].Rubber Age,1974,(11):41-46.
  • 2Gorl U,Schmitt M. Powder rubber-a new raw material generation for simplifying production[J].Rubber World,2001,(06):42-47.
  • 3Gorl U,Schmitt M,Amash A. Rubber/filler compound systems in powder form-A new raw material generation for simplification of the production processes in the rubber industry.Part 1.Powder rubber based on E-SBR/carbon black[J].Kautschuk und Gummi Kunststoffe,2002,(1-2):23-32.
  • 4Amash A,Bogum M,Schuster R H. Continuous mixing of powder rubber in a twin-screw extruder[J].Rubber World,2002,(03):19-21.
  • 5Amash A,Bogun M,Schuster R H. New concepts for continuous mixing of powder rubber[J].{H}Plastics Rubber and Composites,2001,(09):401-405.
  • 6Udo Goerl. Powder rubber systems in the continous mixing process under economical aspects[A].Ohio,2002.1-29.
  • 7艾纯金,郑聚成,朱晶,魏绪玲,徐典宏,高阳光.粉末天然橡胶制备的影响因素分析[J].弹性体,2011,21(3):47-50. 被引量:2
  • 8Zhang A Q,Wang L S,Lin Y L. Carbon black filled powdered natural rubber.preparation,particle size distribution,mechanical properties,and structures[J].{H}Journal of Applied Polymer Science,2006,(03):1763-1774.
  • 9米雄飞,王炼石,张安强,林雅铃.高耐磨炭黑填充型粉末NR研究 (Ⅱ)粒子形貌与成粉机理分析[J].弹性体,2006,16(5):10-12. 被引量:3
  • 10Wang L S,Lin Y L,Zhang A Q. A study on carbon black filled powdered natural rubber:filler dispersion,extruding behavior and mechanical properties[A].Cleveland,2007.

二级参考文献36

共引文献30

同被引文献14

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部