摘要
将聚丙烯腈基炭纤维在石墨化炉中维持定长加热,以模拟炭/炭复合材料制备过程中炭纤维结构的变化,并采用小角X射线散射(SAXS)和高分辨透射电子显微镜(HRTEM)检测石墨化过程中的结构演变。随着温度的提高炭纤维中微孔的平均回转半径、长度、宽度、截面积和体积分数呈现先减小后增大的趋势,并在约2300℃出现极小值。炭纤维中孔隙尺寸的变化与炭层片的活动性密切相关。炭层的缩合和有序化导致孔隙率的减小,而炭层在更高温的簇状化导致孔隙尺寸的增大。
Polyacrylonitrile-based carbon fiber bundles, with two sides fixed, were heated in a graplaitization furnace with temper ature profiles similar to those used in the preparation of carbon/carbon composites, llae microstructure of the microvoids formed was characterized by small-angle X-ray scattering and high resolution transmission electron microscopy (HR-TEM). Results showed that the average radius of gyration of the microvoids decreases, and their length, width, cross-sectional area and volume fraction de crease followed by a slight increase with increasing temperature, with the minima found at around 2300 ℃. The HR-TEM images showed that the microvoids were formed by stacking defects of the carbon layers. The ordering of the amorphous carbon layers ac counted for the initial decrease of size and volume fraction of the voids with increasing temperature, while the growth and ordering of the layers at high temperatures gave rise to increases in their size and volume fraction.
出处
《新型炭材料》
SCIE
EI
CAS
CSCD
北大核心
2014年第1期41-46,共6页
New Carbon Materials
基金
国家自然科学基金(51002165,11079041)
中国科学院山西煤炭化学研究所杰出青年人才培养计划(2011SJCRC09)~~
关键词
炭纤维
小角X射线散射
炭层结构
石墨化
Carbon fibers
Small-angle X-ray scattering
Carbon layer structures
Graphitization