摘要
The non-uniform concentrated solar flux distribution on the outer surface of the absorber tube can lead to large circumferential temperature difference and high local temperature of the absorber tube wall,which is one of the primary causes of parabolic trough solar receiver(PTR)failures.In this paper,a secondary reflector used as a homogenizing reflector(HR)in a conventional parabolic trough solar collector(PTSC)was recommended to homogenize the solar flux distribution and thus increase the reliability of the PTR.The design method of this new type PTSC with a HR was also proposed.Meanwhile,the concentrated solar flux distribution was calculated by adopting the Monte Carlo ray-trace(MCRT)method.Then,the coupled heat transfer process within the PTR was simulated by treating the solar flux calculated by the MCRT method as the heat flux boundary condition for the finite volume method model.The solar flux distribution on the outer surface of the absorber tube,the temperature field of the absorber tube wall,and the collector efficiency were analyzed in detail.It was revealed that the absorber tube could almost be heated uniformly in the PTSC with a HR.As a result,the circumferential temperature difference and the maximum temperature could be reduced significantly,while the efficiency tended to decrease slightly due to the inevitably increased optical loss.Under the conditions studied in this paper,although the collector efficiency decreased by about 4%,the circumferential temperature difference was reduced from about 25 to 3 K and the maximum temperature was reduced from667 to 661 K.
The non-uniform concentrated solar flux distribution on the outer surface of the absorber tube can lead to large circumferential temperature difference and high local temperature of the absorber tube wall,which is one of the primary causes of parabolic trough solar receiver（PTR）failures.In this paper,a secondary reflector used as a homogenizing reflector（HR）in a conventional parabolic trough solar collector（PTSC）was recommended to homogenize the solar flux distribution and thus increase the reliability of the PTR.The design method of this new type PTSC with a HR was also proposed.Meanwhile,the concentrated solar flux distribution was calculated by adopting the Monte Carlo ray-trace（MCRT）method.Then,the coupled heat transfer process within the PTR was simulated by treating the solar flux calculated by the MCRT method as the heat flux boundary condition for the finite volume method model.The solar flux distribution on the outer surface of the absorber tube,the temperature field of the absorber tube wall,and the collector efficiency were analyzed in detail.It was revealed that the absorber tube could almost be heated uniformly in the PTSC with a HR.As a result,the circumferential temperature difference and the maximum temperature could be reduced significantly,while the efficiency tended to decrease slightly due to the inevitably increased optical loss.Under the conditions studied in this paper,although the collector efficiency decreased by about 4%,the circumferential temperature difference was reduced from about 25 to 3 K and the maximum temperature was reduced from667 to 661 K.
基金
supported by the National Natural Science Foundation of China(Grant Nos.51176155 and 51306149)
the Research Project of Chinese Ministry of Education(Grant No.113055A)
关键词
太阳能集热器
通量分布
设计方法
抛物面
非均匀
数值研究
太阳能收集器
人力资源
parabolic trough solar collector,evacuated tubular receiver,secondary reflector,solar flux distribution,temperature distribution
