摘要
介绍了湘钢钢绞线生产线布线机PLC控制系统的组成原理及工作原理,该控制器通过准确计算来调节布线机的走步速度,通过空间限制程序控制布线机的正反向,达到了布线均匀,在PLC设置的换向区内部边界距收线轮边缘5～16mm,外部边界与收线轮边缘齐平的良好效果。
In this paper,composing principle and operation principle on PLC control system on cable enwinding wiring unit were introduced The control system made well calculation,then it adjusted moving velocity of wiring unite The system controlled front—to—back rotation of wiring unit by spatialization programmer Results showed that the wiring unit could equally wind,distance from inner boundary to flange of wheel of wind—up unit was 5～16 mm,outer boundary was equal to flange of wheel of wind—up unit in inversion range controlled by PLC control system
出处
《湖南冶金》
1999年第6期37-39,48,共4页
Hunan Metallurgy
关键词
钢绞线生产
布线机
PLC
控制程序
cable production line,wiring unit,programmable controller
