摘要
通过沉积SiNx薄膜和H2退火表面处理工艺对低成本多晶硅太阳电池进行了处理,对表面处理前后的电池效率进行了对比测试,详细地研究了这两种表面处理工艺对电池的短路电流、开路电压、填充因子和转换效率的影响。实验发现,沉积了SiNx薄膜的低成本多晶硅太阳电池的效率在原有基础上提高了1.8%左右;而经过H2退火后的电池效率则出现了效率衰减。与此同时,对成本相对高的太阳能级多晶硅电池也进行了H2退火,与低成本多晶硅电池相比,其效率增加明显,与低成本太阳电池呈现了相反的现象。最后分析了两种表面处理工艺对电池性能造成影响的原因。
Two surface processing methods, which includes depositing SiNx thin him on the cells and annealing the cells in H2, were carried out on low-cost multi-crystalline silicon solar cells. The efficiency of the solar cells was tested before and after the surface processing. And the effects of the two surface processing methods on the short-circuit current, open-circuit voltage, fill factor and efficiency were carried out in this paper. The results show that the efficiency of the low-cost solar cells is improved by 1.8 % after depositing SiNx thin film on the cells, but after H2annealing, the efficiency is degraded. And high-cost solar-graded multi-crystalline silicon solar cells are also annealed in H2 atmosphere, but its efficiency increases, which shows different tendency compared to low-cost multi-crystalline silicon solar cells. Finally the factors resulting in different effects by the two methods are analyzed and discussed.
出处
《半导体光电》
CAS
CSCD
北大核心
2014年第2期233-236,240,共5页
Semiconductor Optoelectronics
基金
福建省自然科学基金项目(2012J05122)
福建省教育厅B类项目(JB11147)
关键词
多晶硅电池
低成本
表面处理
multi-crystalline silicon solar cells
low-cost
surface processing