摘要
本文介绍轧制热轧带肋钢筋时，在对定尺剪剪切后的定尺成品观察后，成品外观呈周期性的波浪形状，经过测量严重部位的单米弯曲度在0．4％～0．10％，不满足《GB 1499．2-2007钢筋混凝土用钢》国标要求，同时影响着产品外观质量；工艺改进之后，无论产品总长度弯曲度还是单米弯曲度，均控制在国标4％的范围内，进一步提高了产品外观质量，提高了酒钢热轧带肋钢筋的品牌形象。
When observing finished products after the procedure of length shear during the production of hot ribbed bars , periodic wave-shaped bending is found on the appearance of finished products .The most serious parts are measured to have a 0.4%~0.10%bending degree per meter which fails to meet the standard of ＆lt;GB 1499.2-2007 for concrete reinforcement steel＆gt;, and has a bad influence on appearance quality of finished products .After improving the process , either bending de-gree of total length or per meter is controlled within 4%recording to the standard mentioned before .This achievement plays a great role in further improving appearance quality and contributes a lot to the hot ribbed bar brand image of JISCO .The specifics will be discussed in this paper .
出处
《甘肃冶金》
2014年第2期45-47,50,共4页
Gansu Metallurgy
关键词
带肋钢筋
波浪弯
成品孔型
弯曲度
上冷床温度
ribbed bar wave-shaped
bending
finished pass
bending degree
temperature on the cooling bed
