摘要
利用Saber仿真软件完成无刷直流电机控制系统的研究分析。分别对控制系统中的位置传感器、电子换向器、三相逆变电路进行研究与分析,并完成仿真模型的搭建、功能验证和性能分析,最后对各功能模块进行有机整合,完成控制系统的整体仿真试验,仿真结果证明,系统设计合理,其仿真结果与理论分析相吻合。
A BLDCM control system was researched and analyzed using Saber software. The position detection sensor, the electronic commutator module and three-phase inverter circuits of the control system were studied, and the simulation models were established respectively. Then the functional verification test and performance analysis were performed. By the organic combination of these blocks, the overall performance was simulated. The simulation results showed that the system design was reasonable and the results were consistent with the theoretical analysis.
出处
《电子设计工程》
2014年第10期151-155,共5页
Electronic Design Engineering
关键词
无刷直流电机
位置传感器
电子换向器
三相逆变电路
BLDCM
position detection sensor
electronic commutators
three-phase inverter circuits
