期刊文献+

硅树脂的结构、性能与断裂行为研究 被引量:3

The Structure,Properties and Fracture Behaviors of Silicone Resin
下载PDF
导出
摘要 采用甲基氯硅烷和苯基氯硅烷合成了一系列不同R/Si的甲基苯基硅树脂,并研究了不同R/Si结构对硅树脂弯曲性能的影响.红外和热重分析结果表明,制备的有机硅树脂为含羟基的甲基苯基硅树脂,具有很好的耐热稳定性.固化后得到的有机硅树脂材料,其弯曲性能随着R/Si的增大呈轻微的提高后有明显的降低,当R/Si为1.2时其弯曲强度达到最大,约为22MPa.基于对材料断裂形貌的观察和分析,文章讨论了硅树脂断裂行为的差异及其与弯曲性能的关系. A series of methylphenyl silicone resin with different R/Si ratios were synthesized by using methyl chlorosilane and phenyl chlorosilane as the materials ,and the effects of different R/Si ratios on the flexural properties of silicon resin were investigated .The FT‐IR and TGA results indicate that the produced resin is methylphenyl silicone resin containing the hydroxyl group ,showing good thermal stability .Along with the increase of R/Si ratio ,the flexural properties of cured silicone resin slightly increases then significantly decreases .The silicone resin with R/Si ratio of 1 .2 presents the maximum flexural strength of about 22 M Pa .Basing on the observation and analysis of fracture surface ,the paper discusses the differences in the fracture behaviors of silicone resin and the relations correlated with the flexural properties .
出处 《杭州师范大学学报(自然科学版)》 CAS 2014年第3期225-229,共5页 Journal of Hangzhou Normal University(Natural Science Edition)
基金 国家自然科学基金项目(51203038) 浙江省科技创新团队项目(2009R50016-16) 浙江省公益性技术应用研究计划项目(2013C31079) 浙江省国际科技合作项目(2013C24020) 杭州师范大学科研启动基金项目(2012QDL022)
关键词 硅树脂 R Si比 弯曲性能 断裂行为 silicone resin R/Si ratio flexural properties fracture behaviors
  • 相关文献

参考文献8

  • 1幸松民,王一璐.有机硅合成工艺与产品应用[M].北京:化学工业出版社,2003.
  • 2吕建,蒋蕴菊,梁亚东.SM—80改性硅酮模塑料的研究[J].绝缘材料通讯,1994(5):3-9. 被引量:3
  • 3罗运军,桂红星.有机硅树脂及其应用[M].北京:化工出版社,2001.
  • 4Dvornic P D, Lenz R W. Exactly alternating silarylene-siloxane polymers Ⅱ: the condensation polymerization of arylenedisilanols and bisureidosilanes[-J]. Journal of Polymer Science: Polymer Chemistry Edition, 1982,20(4) :951-966.
  • 5孙举涛,黄玉东,曹海琳,巩桂芬.耐高温有机硅树脂的合成及其耐热和固化性能研究[J].航空材料学报,2005,25(1):25-29. 被引量:72
  • 6于杰,金志浩,周惠久.聚苯乙烯冲击断口的几种典型形貌[J].电子显微学报,1993,12(4):324-329. 被引量:3
  • 7Zhang H, Tang L C, Zhang Z, et al. Fracture behaviours of in situ silica nanoparticle-filled epoxy at different temperatures[J]. Poly- mer, 2008,49 : 3816-3825.
  • 8Le Q H, Kuan H C, Dai J B, et al. Structure-property relations of 55 nm particle-toughened epoxy[J]. Polymer,2010,51:4867-4879.

二级参考文献23

  • 1王清正,师彤,谢择民,孙羡,王金亭,李光亮.硅氮聚合物交联剂交联的室温硫化硅橡胶的热稳定性[J].高分子学报,1994,4(5):573-577. 被引量:30
  • 2肖亮灿,李仲彰,杜玲仪.PMMA断口形态及其破坏机理[J].高分子材料科学与工程,1990,6(4):61-65. 被引量:9
  • 3幸松民.有机硅单体及聚合物[M].北京:化学工业出版社,1986..
  • 4JELENA D J, MILUTIN N G. The thermogravimetric analysis of some polysiloxanes [ J]. Polymer Degradation and Stability, 1998,61:87 - 93.
  • 5SCHMIDT M J J,LOW D K Y,LI L. Laser ablation of B4Cpolysiloxane composite [ J ]. Applied Surface Science,2002,186:271 - 275.
  • 6KEIJMAN K. Use of novel siloxane hybrid polymers in protective coatings [ J]. Oil Gas-European Magazine. 1997,23(3): 38 -40.
  • 7BRYTE. High performance radome & antenna materials[J]. High Performance Composites, 1999, ( 1 ): 15 - 23.
  • 8ADHAKRISHNAN T S. New method for evaluation of kinetic parameters and mechanism of degradation from pyrolysis-GC studies: thermal degradation of polydimethylsiloxanes [ J ]. Journal of Applied Polymer Science, 1999,73:441 - 450.
  • 9ODON W, GABOR K. A new catalytic method for crosslinking of silicone polymers [ J ]. Journal of Applied Polymer Science. 1998, 69: 1705 - 1709.
  • 10ZHANGYM, YING H, LIU X L and YU Y Z. Studies on the silicone resins cured with polymethylsilazanes at ambient temperature [ J ]. Journal of Applied Polymer Science ,2003,89:1702 - 1707.

共引文献83

同被引文献639

引证文献3

二级引证文献11

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部