高职模具专业《模具测绘技术》课程教学改革探讨

Discussion on teaching reform of“Die & Mould Surveying and Mapping Technology”curriculum for die & mould specialty in vocational schools

分析了高职模具专业传统基础课程设置的不足,结合模具专业人才培养模式和课程体系改革要求,以培养岗位实际需要为目标,从重组教学内容、改进教学方法及考核评价体系等方面,探讨了《模具测绘技术》课程的教学改革思路和方法。

The deficiency in provision of traditional basic course for die ＆ mould specialty in vocational colleges was analyzed. Some ideas and methods in the reform of ＂Die ＆ Mould Surveying and Mapping Technology＂ curriculum were proposed from aspects of re- combination of teaching contents, improvement of teaching methods and assessment evaluation system and by combining the requirements for personnel training mode and course sys- tem reform and for actual post demand.