摘要
分析了水箱上安装支架冲压成形工艺,改进了适合该零件生产要求的冲压工艺方案,采用3副组合冲模进行冲压生产,提高了生产效率,改善了产品质量,且设备资源得到了充分有效地利用。实践证明,该水箱上安装支架冲压成形工艺和模具结构有效而可行。
The stamping process of the mounting bracket on the water tank was analyzed.With 3 pairs of combination stamping dies, the forming process was improved to satisfy the products property and improve the manufacture efficiency, while the equipment resources also could be used more efficiently. It is proved that this stamping process and die structure of the support were effective and feasible.
出处
《模具技术》
2014年第3期11-15,共5页
Die and Mould Technology
关键词
工艺优化
直通式结构
刚性成形
镦压
分块式结构
optimized forming process
straight-through structure
rigid forming
upsetting pressure
block structure
