摘要
A lean-burn internally-staged combustor for low emissions that can be used in civil avi-ation gas turbines is introduced in this paper. The main stage is designed and optimized in terms of fuel evaporation ratio, fuel/air pre-mixture uniformity, and particle residence time using commer-cial computational fluid dynamics （CFD） software. A single-module rectangular combustor is adopted in performance tests including lean ignition, lean blowout, combustion efficiency, emis-sions, and combustion oscillation using aviation kerosene. Furthermore, nitrogen oxides （NOx） emission is also predicted using CFD simulation to compare with test results. Under normal inlet temperature, this combustor can be ignited easily with normal and negative inlet pressures. The lean blowout fuel/air ratio （LBO FAR） at the idle condition is 0.0049. The fuel split proportions between the pilot and main stages are determined through balancing emissions, combustion efficiency, and combustion oscillation. Within the landing and take-off （LTO） cycle, this combustor enables 42%NOx reduction of the standard set by the 6th Committee on Aviation Environmental Protection （CAEP/6） with high combustion efficiency. The maximum board-band pressure oscillations of inlet air and fuel are below 1%of total pressure during steady-state operations at the LTO cycle specific conditions.
A lean-burn internally-staged combustor for low emissions that can be used in civil avi-ation gas turbines is introduced in this paper. The main stage is designed and optimized in terms of fuel evaporation ratio, fuel/air pre-mixture uniformity, and particle residence time using commer-cial computational fluid dynamics （CFD） software. A single-module rectangular combustor is adopted in performance tests including lean ignition, lean blowout, combustion efficiency, emis-sions, and combustion oscillation using aviation kerosene. Furthermore, nitrogen oxides （NOx） emission is also predicted using CFD simulation to compare with test results. Under normal inlet temperature, this combustor can be ignited easily with normal and negative inlet pressures. The lean blowout fuel/air ratio （LBO FAR） at the idle condition is 0.0049. The fuel split proportions between the pilot and main stages are determined through balancing emissions, combustion efficiency, and combustion oscillation. Within the landing and take-off （LTO） cycle, this combustor enables 42%NOx reduction of the standard set by the 6th Committee on Aviation Environmental Protection （CAEP/6） with high combustion efficiency. The maximum board-band pressure oscillations of inlet air and fuel are below 1%of total pressure during steady-state operations at the LTO cycle specific conditions.
