摘要
采用注塑成型方法制备了通用膜料DFDA-7042试样,研究了注塑条件对试样力学性能的影响,并对加工条件进行了优选.结果表明,适宜的注射压力在3 ~5 MPa之间,保压压力在3~4.5 MPa之间,保压时间设定在20 s,冷却时间设定在30~45 s之间,注射速率设定在100~ 120 mm/s.
General membrane material DFDA-7042 was prepared by injection molding process,and the effect of injection molding process on the mechanical properties of sample was studied.The processing conditions were preferred.The results showed that:the appropriate injection pressure was between 3 ~5 MPa,holding pressure was between 3 ~4.5 MPa,holding time was set to 20 s,cooling time was between 30 ~45 s,and injection speed was between 100 ~ 120 mm/s.
出处
《塑料工业》
CAS
CSCD
北大核心
2014年第6期60-63,共4页
China Plastics Industry
关键词
注塑工艺
聚乙烯
力学性能
Injection Process
Polyethylene
Mechanical Property