相关原则与量规工作尺寸的设计计算

Tne Interrelated Principle &The Design And Calculation of The Gage-worked Size

本文在《光滑极限量规》国家标准的基础上,探讨了一般标注形式的孔、工作量规工作尺寸的计算方法和计算公式。并举出设计实例。

On the basis of the state standard 'smooth limit gage', this article researches the calculatingmethod and formula of the gage - worked size of hole and shaft ofgeneral labeled form. And it is illustrated with examples.