摘要
本文介绍了Plucker线坐标几何,研究了螺旋的Plucker坐标表示及其螺旋和的计算,用Plucker坐标研究了产形轮几何问题,计算了瞬轴面沿齿轮轴线公垂线的长度,解决了瞬轴面长度计算公式的问题。
After an introduction of the Plucker coordinate geometry, a discussion is made of the expression of screws in Pliicker coordinates and the addition of screws, As a results, the geometry of generating gears is re-studied and a formula is dcrvicd for calculating the axodc length of hypoid gears, a length as distributed along the gear axle
关键词
齿轮
坐标
螺旋齿轮
拟圆柱面
coordiates
screw gears
generating
gcar/Plucker
cylindriod
axode
