基于单片机的锯切机动态跟踪系统

Dynamic Following for the Sawing Mail of Rolling Mail Based on Single Chip Microcomputer

以 8 9C2 0 5 1单片机为核心 ,以数字逻辑为基础 ,采用双机通讯的方式 ,完成匀加速运动锯切机动态跟踪匀速运动型材 ,并进行定长切割的过程 .分析了锯切机运动特点及控制算法 ,介绍了其硬件组成及软件流程 .

The dynamic following process is completed by two computer communication based on 89C2051 single chip microcomputer and digital logic. In this process the uniform\|speedup\|motion Sawing follows the uniform\|speed\|motion Section Bar and incises the preconcerted length. This paper analyses the motion character and control arithmetic and introduces the hardware and software.