期刊文献+

弧齿锥齿轮齿面优化修正及计算机仿真 被引量:19

Optimal Tooth Surface Correction of Spiral Bevel Gears and Computerized Simulation
下载PDF
导出
摘要 由于加工误差和热处理变形等因素的影响 ,实际弧齿锥齿轮齿面啮合质量通常与“轮齿接触分析”(TCA)所得的理论结果有所差异。本文提出了基于最小二乘法的加工参数识别方法和齿面优化修正方法 ,经计算机仿真验证 ,修正后的齿面与原设计的齿面 ,具有非常近似的 TCA结果。 Due to unavoidable manufacturing errors and heat treatment distortions,the bearing pattern and kinematical behavior of actual spiral bevel gear drives are usually different from the analytical results of the original design obtained by Tooth Contact Analysis (TCA) technique.In this paper,an identification approach to determining the machine setting corrections by using Least Square Method is presented.A numerical example by means of computerized simulation shows the agreement of TCA results between corrected tooth surface and the original design,including the bearing pattern and kinematical behavior.
出处 《航空动力学报》 EI CAS CSCD 北大核心 2002年第1期140-144,共5页 Journal of Aerospace Power
关键词 弧齿锥齿轮 齿面修正 优化 计算机仿真 最小乘法 轮齿接触分析 spiral bevel gear tooth flanks correction
  • 相关文献

参考文献5

  • 1[1]Litvin F L.Identification and Minimization of Deviations of Real Gear Tooth Surfaces[J].ASME.J.of Mechanical Design,1991,113(1):55-61.
  • 2[2]Zhang Y.Computerized Analysis of Meshing and Contact of Gear Real Tooth Surfaces[J].ASME.J.of Mechanical Design,1994,(3):677-682.
  • 3[3]Gosselin C.Identification of the Machine Settings of Real Hypoid Gear Tooth Surfaces[J].ASME.J.of Mechanical Design,1998,120(2):429-440.
  • 4[4]Lin C Y.Computer-Aided Manufacturing of Spiral Bevel and Hypoid Gears with Minimum Surface-Deviation[J].Mech.Mach.Theory,1998,33(6):785-803.
  • 5[5]Litvin F L.Local Synthesis and Tooth Contact Analysis of Face-Milled Spiral Bevel Gears[R].NASA C.R.,4342,1990

同被引文献156

引证文献19

二级引证文献128

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部