摘要
W-30 wt%Cu and TiC-50 wt%Ag were successfully synthesized by a novel simplified pretreatment followed by electroless plating. The 0 wt% TiC, 0.5 wt% TiC, and 0.5 wt%TiC-0.5 wt%Ag composite powders were added to W-30 wt%Cu composite powders by blending, and then reduced. The reduced W-30 Cu, W-30 Cu/0.5 TiC, and W-30 Cu-0.5 Ag/0.5 TiC composite powders were then compacted and sintered at 1 300 ℃ in protective hydrogen for 60 min. The phase and morphology of the composite powders and materials were analyzed using X-ray diffraction and field emission scanning electron microscopy. The relative density, electrical conductivity, and hardness of the sintered samples were examined. Results showed that W-30 Cu and TiC-Ag composite powders with uniform structure were obtained using simplified pretreatment followed by electroless plating. The addition of TiC particles can significantly increase the compressive strength and hardness of the W-30 Cu composite material but decrease the electrical conductivity. Next, 0.5 wt% Ag was added to prepare W-30 Cu-0.5 Ag/TiC composites with excellent electrical conductivity. The electrical conductivity of these composites(61.2%) is higher than that in the national standard(the imaginary line denotes electrical conductivity of GB IACS 42%) of 45.7%.
W-30 wt%Cu and TiC-50 wt%Ag were successfully synthesized by a novel simplified pretreatment followed by electroless plating. The 0 wt% TiC, 0.5 wt% TiC, and 0.5 wt%TiC-0.5 wt%Ag composite powders were added to W-30 wt%Cu composite powders by blending, and then reduced. The reduced W-30 Cu, W-30 Cu/0.5 TiC, and W-30 Cu-0.5 Ag/0.5 TiC composite powders were then compacted and sintered at 1 300 ℃ in protective hydrogen for 60 min. The phase and morphology of the composite powders and materials were analyzed using X-ray diffraction and field emission scanning electron microscopy. The relative density, electrical conductivity, and hardness of the sintered samples were examined. Results showed that W-30 Cu and TiC-Ag composite powders with uniform structure were obtained using simplified pretreatment followed by electroless plating. The addition of TiC particles can significantly increase the compressive strength and hardness of the W-30 Cu composite material but decrease the electrical conductivity. Next, 0.5 wt% Ag was added to prepare W-30 Cu-0.5 Ag/TiC composites with excellent electrical conductivity. The electrical conductivity of these composites(61.2%) is higher than that in the national standard(the imaginary line denotes electrical conductivity of GB IACS 42%) of 45.7%.
基金
Funded by the National Magnetic Confinement Fusion Program(No.2014GB121001)
