多骨位塑件注射模设计

Design of Injection Mold for the Multi-Bone Plastic Parts

根据多骨位塑件的结构与工艺要求,制定了适合该此类塑件的模具设计方案,模具采用两板模结构,模具无滑块结构,浇注系统采用潜伏式进胶结构,塑件内部有众多骨位,顶出系统设计时需要注意塑件顶出平衡,使模具可以大批量生产。

According to the structure and technological requirements of plastic products with multi-bone,the design scheme of the mold suitable for this kind of parts is formulated.The mold adopts two-plate mold structure,and the mold has no slider structure.There are many bones in the product.The ejection balance of the product should be paid attention to when designing the ejection system,so that the mold can be produced in large quantities。