摘要
本文介绍了一种聚酯薄膜分切机放卷机张力自适应控制系统 ,系统采用西门子 S5 - 115 U PL C,交流传动采用 6 SE70 2 4矢量控制变频器 ,多种检测信号通过 ET- 2 0 0分布式 I/ O组件由 Profibus- DP传送至PL C.文中介绍了放卷机张力控制的调节原理 ,由于带薄膜的放卷辊直径变化范围很大 ,放卷辊的转动惯量变化范围很大 ,为此系统中采用了自适应控制原理 ,由 PL C、变频器及光电编码器构成转速环 ,并在放卷机转速环的前向通道中 ,设置 1个与放卷辊直径的平方成比例的系数 ,以抵消其转动惯量的变化 ,使转速环在放卷辊直径变化时始终具有良好的动态性能 .仿真实验结果验证了该方法的有效性 .实际使用也得到了优良的张力控制效果 .
This Paper introduces a self adaptive tension control system used for the unwinder in a polyester film slitter. Siemens S5 115UPLC is used in the system and 6SE7024 vector control converter is used as its AC driver. Several measured signals are transmitted to PLC via ET 200 distributed I/O module and Profibus DP. In this paper the tension control principle of the unwinder is introduced. Because the range of the roller diameter varies widely, its moment of inertia also varies wildly. For this reason the principle of self adaptive control is used in the system. The SR loop of the system is made up of PLC, Converter and photoelectricity encoder. In the control channel of the SR loop a parameter is chosen, which is proportional to the square of the roller diameter, to compensate for the variation of the moment of inertia. By this way the SR loop can possess good dynamic properties the whole time during the variation of the roller diameter. The simulation results prove the validity of the method and the good tension control effect is gained in application.
出处
《信息与控制》
CSCD
北大核心
2002年第2期122-126,共5页
Information and Control
基金
江苏省教育厅自然科学基金 0 0 KJB470 0 0 3项目资助
