期刊文献+

压气机叶轮工艺改进

Improvement on Technology of Aerostatic Press Vane Wheel
下载PDF
导出
摘要 对压气机叶轮的异常金相组织进行了分析,认为型壳透气性不好,导热能力差,使得铸件凝固完毕后硅仍然保持很大的扩散速度是导致共晶硅聚集的主要原因。针对以上原因及压气机叶轮的生产工艺,提出用铝矾土型壳代替水玻璃型壳,并将铸型由装箱改为单壳浇注,控制合理的铸型温度及浇注工艺参数,金相组织中共晶硅更为细小,共晶硅聚集现象消失。
出处 《中国铸造装备与技术》 CAS 北大核心 2002年第3期42-44,共3页 China Foundry Machinery & Technology
  • 相关文献

参考文献4

  • 1[1]Dudyk By M.The influence of Modification,using Strontium and Antimony,on the Properties of AlSi6Cu2Mg and AlSi8Cu4MgMn Aluminium Alloys used for Automobile Castings. CAST M ETA LS, 1990,3 ( 3 ): 157~162
  • 2[2]DAHLE A K.Eutectic Nucleation and Growth in Hupoeutectic Al-Si Alloys at Different Strontium Levels. METALLURGICALAND MATETIALS TRANS-ACTIONS, 2001,32A(ApriL) :949~960
  • 3[3]0UELLET P.Effect of Mg on the ageing behaviour of Al-Si-Cu 319 type alu-minium casting alloys.JOURNAL OF MATERIALS SCIENCE, 1999,34:4671~4679
  • 4[4]Dons A L.The origin of anomalous microsegregation in Al-Si foundry alloys modelling and experimental vertification. Materials Scienee and Engineering,1999,A271:91~94

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部