期刊文献+

高速PCB同步开关噪声仿真抑制分析 被引量:1

Suppression Analysis of SSN Simulation in High-Speed PCB
下载PDF
导出
摘要 从电源完整性(PI)的角度分析了抑制同步开关噪声(SSN)的有效途径——降低芯片供电电源的输入阻抗。使用目标阻抗法,并对给定最大去耦电容容值种类的条件下,使用频域对数法进行电源地分配网络(PDN)的优化。以XX电子控制器的PCB板为例,使用Ansoft SIwave及Ansoft Designer仿真软件,对复杂高速PCB板PDN进行优化设计,并通过时域观察优化前后SSN的抑制情况。仿真结果表明:通过优化PDN能够有效降低SSN。 From the aspect of Power Integrity ( PI ) , the effective way of suppressing simultaneous switching noise ( SSN) is reduce chip’s input impedance. With the method of target impedance determined by the number of decoupling capacitance which frequency domain logarithmic is used to optimize power delivery network ( PDN ) . Based on XX-electronic-controller PCB,a high-speed complicated PCB’ PDN is analyzed and optimized by Ansoft SIwave and using time-domain observes the inhibition of SSN by Ansoft Designer. The simulation resultes show that the optimization of power distribution network can reduce SSN effectively.
出处 《电子器件》 CAS 北大核心 2014年第4期609-612,共4页 Chinese Journal of Electron Devices
关键词 电源完整性 同步开关噪声 目标阻抗 ANSOFT SIwave Ansofi DESIGNER PI SNN target impedance Ansoft SIwave Ansoft Designer
  • 相关文献

参考文献6

  • 1Senthinathan R,Prince J L. Simultaneous Switching Ground Noise Calculation for Packaged CMOS Devices [ J ]. IEEE Journal ot Solid-State Circuits, 1991,26( 11 ) : 1724-1728.
  • 2Swaminathan M, Chung Daehyun, Grivet-Talocia Stefano, et al. Designing and Modeling for Power lnlegrity [ J ]. IEEE Transactions on Electromagnetic Compatibility,2010,52(2) :288-309.
  • 3闫静纯,李涛,苏浩航.高速高密度PCB电源完整性分析[J].电子器件,2012,35(3):296-299. 被引量:13
  • 4Smith Larry D, Anderson Raymond E, W Forehand Douglas, et al. Power Distribution System Design Methodology and Capacitor Selection for Modem CMOS Technolngy [ J ]. iEEE Transtratiomm Advanced Packaging, 1999,22 ( 3 ) :284-290.
  • 5Weir Steve, Teraspeed Consulting Gruup. Bypass Filter Design Considera-tions for Modem Digital Systems, A Comparative Evaluation of the Big " V" , Multi-pole, and Many Pule Bypass Strategies. Design Con ,2006.
  • 6杨丽湘.基于遗传算法的电源分配网络设计[D].西安:西安电子科技大学,2010.

二级参考文献8

  • 1白同云.高速PCB电源完整性研究[J].中国电子科学研究院学报,2006,1(1):22-30. 被引量:27
  • 2Sridharan V,Swaminathan M, Bandyopadhyay T. Enhancing Signal and Power Integrity Using Double Sided Silicon Interposer [ J ]. IEEE Microwave and Wireless Components Letters,2011,21 ( 11 ) : 598-600.
  • 3Swaminathan M, Kim J, Novak 1, et al. Power Distribution Networks for System on Package: Status and Challenges [ J ]. IEEE Transactions on Advanced Packaging,2004,27 ( 2 ) :286-300.
  • 4Tzong-Lin Wu, Hao-Hsiang Chuang, Ting-Kuang Wang. Overview of Power Integrity Solutions on Package and PCB : Decoupling and EBG Isolation [ J ]. IEEE Transactions on Electromagnetic: Compatibility ,2010,52( 2 ) :346-356.
  • 5MadhavanSwaminathan,EgeEnginA.著.芯片及系统的电源完整性建模与设计[M].李玉山,等译.北京:电子工业出版社,2009,11-14.
  • 6林少晶.板级电源的完整性设计及验证方法[J].广东科技,2009,18(12):211-213. 被引量:1
  • 7周子琛,申振宁.高速嵌入式系统中的电源完整性设计方法[J].单片机与嵌入式系统应用,2010,10(3):19-21. 被引量:4
  • 8李学平,李玉山.基于Ansoft仿真分析的SSN解决方案探讨[J].微型机与应用,2011,30(4):68-70. 被引量:5

共引文献12

同被引文献3

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部