摘要
介绍了手机外壳在注射成型过程中产生喷射纹的原因及解决措施,结合实际生产情况及客户要求,采用Moldflow分析了塑件在成型过程中不同熔料的流动及充填型腔状况,通过将塑件材料由PC更换为PC+ABS,解决了塑件的喷射纹问题,塑件的质量外观及尺寸均达到设计要求。
The cause of injection stria on the surface of a mobile phone shell in the injection moulding process and the solutions were presented. The flow and filling conditions ofdifferent types of material, combined with actual production and customer requirements, were analyzed by Moldflow. The injection stria problem was finally resolved by replacing PC material with PC & ABS.
出处
《模具工业》
2014年第8期24-26,33,共4页
Die & Mould Industry