普车改做滚压工装

Modification of Rolling Frock with General Lathe

该文描述了将正要报废的C6125车床改装后作为滚压工装,这个不单单的是机床改造,还有气路,电路改制,还有一个更重要的要求是效率要高,自动化程度要求也高。经过对设备的了解,以及跟电路工程师沟通,一致认为可以一试。

This paper describes the C6125 lathe was changed into roll frock which is scrap. This is not only the machine reformation but also gas and circuit reformation. There is a more important requirement is high efficiency, high degree of automation requirements. Through knowing the equipment and communicating with the circuit engineer, we can have a try.