期刊文献+

均匀化处理对Cu-Cr-Zr合金显微组织的影响 被引量:1

Effects of homogenization treatment on the microstructure of Cu-Cr-Zr alloy
下载PDF
导出
摘要 采用OM、SEM和TEM分析手段对Cu-Cr-Zr合金的铸态和均匀化组织进行研究.结果表明,Cu-Cr-Zr合金的铸态组织呈典型的枝晶状组织,主要由网状的Cr枝晶、共晶组织和基体组成,其中共晶组织是由基体和层片状的Cu5Zr相组成.在Cu-Cr-Zr合金的均匀化退火过程中,发生共晶组织的溶解和Cr相的析出.随着均匀化退火温度和时间的升高和延长,共晶组织逐渐溶解,Cr相的析出体积分数逐渐减小.合理的均匀化退火制度为900℃×12 h. The as-cast and homogeneous microstructures are analyzed by optical microscope, scanning electron microscope and transmission electron microscope. The results show that the as-cast microstructure of Cu-CrZr alloy is typical dendritic structure which is mainly made up of Cr dendrite and eutectic structures and matrix. Eutectic structures are composed of Cu and Cu5 Zr phase with a fine lamellar structure. By increasing the homogenization temperature or prolonging the holding time, the eutectic structure is dissolved into the matrix gradually with obvious reduced fraction volume and Cr phases. The proper homog enizing process is900 ℃×12 h.
出处 《有色金属科学与工程》 CAS 2014年第5期68-73,共6页 Nonferrous Metals Science and Engineering
基金 北京市科技项目(10231103) 科研院所技术开发研究专项基金(2011DIA5k023)
关键词 CU-CR-ZR合金 均匀化处理 显微组织 Cu-Cr-Zr alloy homogenization treatment microstructure
  • 相关文献

参考文献23

  • 1Liu Q, Zhang X, Ge Y, et al. Effect of processing and heat treatment on Behavior of Cu-Cr-Zr alloys to railway contact wire[J]. Metallurgical and Materials Transactions A,2006,37(11):3233-3238.
  • 2Batra I S. Microstructure and properties of a Cu-Cr-Zr alloy[J]. Journal of Nuclear Materials,2001,299(2):91-100.
  • 3HolzwarthU, Stamm H. The precipitation behavior of ITER-grade Cu-Cr-Zr alloy after simulating the thermal cycle of hot isostatic pressing[J]. Journal of Nuclear Materials,2003,279(1):31-45.
  • 4沈斌,程建奕,李海英.Cu-Cr-Zr-Mg合金的相变动力学[J].材料热处理学报,2014,35(9):121-125. 被引量:4
  • 5张毅,李瑞卿,许倩倩,田保红,刘勇,刘平,陈小红.Cu-Cr-Zr合金的高温热压缩变形行为[J].中国有色金属学报,2014,24(3):745-751. 被引量:7
  • 6Huang F X, Ma J S, Ning H L, et al. Analysis of phase in a Cu-Cr-Zr alloy[J]. Scripta Material,2003,48(1):97-102.
  • 7Chbihi A , Sauvage X , Blavette D. Atomic scale investigation of Cr precipitation in copper [J]. Acta materialia,2012,60(11):4575-4585.
  • 8Knights R W, Wilkes P. Precipitation of chromium in copper and copper-nickel base alloys[J]. Metallurgica Transaction,1973,4(10):2839-2393.
  • 9Weatherly G C, Humble P, Borland D. Precipitation in a Cu-0.55 wt% Cr alloy[J]. Acta Metallurgica ,1979,27(12):1815-1828.
  • 10Komen Y, Rezek J. Precipitation at coherency loss in Cu-0.35 wt pct Cr[J]. Metallurgica Transacation A,1975,6(3):549-551.

二级参考文献25

  • 1黄金亮,叶权华,刘平,刘勇,田保红.用导电率研究Cu-Cr-Zr-Y合金的相变动力学[J].材料热处理学报,2006,27(2):132-136. 被引量:11
  • 2慕思国,汤玉琼,郭富安,唐谟堂,彭长宏.Cu-Cr-Zr系合金非真空熔炼过程的热力学分析[J].中国有色金属学报,2007,17(8):1330-1335. 被引量:12
  • 3刘勇,龙永强,刘平,田保红.液固两相介质流中Cu-Cr-Zr合金的冲蚀磨损行为[J].中国有色金属学报,2007,17(10):1650-1655. 被引量:9
  • 4XIA Cheng-dong, JIA Yan-lin, ZHANG Wan, ZHANG Ke, DONGQi-yi, XU Gen-ying, WANG Ming-pu. Study of deformation and aging behaviors of a hot rolled-quenched Cu-Cr-Zr-Mg-Si alloy during thermomechanical treatments[J]. Materials Design, 2012, 39: 404-409.
  • 5BI Li-ming, LIU Ping, CHEN Xiao-hong, LIU Xin-kuan, LI Wei, MA Feng-cang. Analysis of phase in Cu-15%Cr-0.24%Zr alloy[J]. Transactions of Nonferrous Metals Society of China, 2013, 23(5): 1342-1348.
  • 6ZHANG Hui, ZHANG Hong-gang, LI Luo-xing. Hot deformation behavior of Cu-Fe-P alloys during compression at elevated temperatures[J]. Journal of Materials Processing Technology, 2009, 209(6): 2892-2896.
  • 7ZHANG L, LI Z, LEI Q, QIU W T, LUO H T. Hot deformation behavior of Cu-8.0Ni-1.8Si-0.15Mg alloy[J]. Materials Science and Engineering A, 2011, 528(3): 1641-1647.
  • 8GRONOSTAJSKI Z. The deformation processing map for control of microstructure in CuAl9.2Fe3 aluminium bronze[J]. Journal of Materials Processing Technology, 2002, 125/126: 119-124.
  • 9SRINIVASAN N, PRASAD Y V R K, RAO P R. Hot deformation behavior of Mg-3Al alloy study using processing map[J]. Materials Science and Engineering A, 2008, 476(2): 146-156.
  • 10PRASAD Y V R K, RAO K E Processing maps for hot deformation of rolled AZ31 magnesium alloy plate: Anisotropy of hot workability[J]. Materials Science and Engineering A, 2012, 487(1/2): 316-327.

共引文献55

同被引文献10

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部