摘要
针对硬目标侵彻引信实验室实物模拟实验,提出了利用多次冲击实验机对硬目标侵彻过程进行模拟实验方法的研究。介绍了硬目标侵彻引信的计层数策略,讨论利用冲击过程模拟侵彻过程加速度信号的可行性,设计了模拟实验系统并针对某型号侵彻引信进行计层数起爆模拟实验。通过与靶场试验曲线的对比,验证了该模拟实验方法的可行性,可较全面地检测引信起爆控制算法的准确性,以及引信活动部件动作的可靠性;但冲击峰值较低,冲击间隔较长,需要做进一步的研究和完善。
A method of using the repeated impact machine to simulate the process of hard target penetration is proposed for the physical simulation experiment of hard target penetration fuze. The layer-count algorithm of hard target penetration fuze is introduced. The feasibility of simulating the penetration acceleration signal by use of the impact process is discussed. A simulation experimental system is designed,and a layer-count detonating experiment is done using a certain type of penetration fuze. The result is compared with shooting range test curve,proving the feasibility of the simulation experimental methods. The accuracy of fuze burst point control method can be comprehensively tested. The reliability of fuze moving parts can be testified. Further research is needed as the shock acceleration peak is low and the shock interval is long.
出处
《兵工学报》
EI
CAS
CSCD
北大核心
2014年第10期1556-1561,共6页
Acta Armamentarii
基金
武器装备预先研究项目(51305060203)
关键词
兵器科学与技术
侵彻引信
冲击试验
模拟实验
计层数
ordnance science and technology
penetration fuze
shock experiment
simulation experiment
layer-count