期刊文献+

超大型油船破损剩余强度可靠性分析

Reliability analysis of residual strength of VLCC
下载PDF
导出
摘要 根据MARPOL公约,对CSR-H规定的破口范围进行概率分析。以一艘超大型油船为例,分别统计了单舱破损后各个肋位的静水弯矩概率特征和基于全球海况谱的一周波浪弯矩预报值;基于Smith法的船体梁极限弯矩计算软件,分别统计了各舱破损后极限弯矩的概率特征;采用改进一次二阶矩法,计算了各舱破损后的剩余强度可靠度。研究结果表明:机舱和首尾货舱发生破损后整船失效概率较低,中部货舱区域发生破损后整船失效概率较大,尤其在静水中垂破损工况下最危险,失效概率在10-2量级。 According to MARPOL Convention, this paper analyzes the probability of the damage extent which is specified by CSR-H rules. Taking a VLCC as an example, it adds up its probability characteristics of still water bending moment of each frame for a single damaged cabin, and calculates the predicted value of wave bending moment during a week based on global sea spectrum. It also counts the probability characteristics of the ultimate bending moment for the each damaged cabin by a software for the calculation of ship beam ultimate bending moment with Smith method, and calculates the reliability of its residual strength by the improved FOSM method. The analysis results show that the failure probability for the whole tanker is small when the engine room and fore and aft cargo hold are damaged, however, it becomes bigger when the central cargo hold area is damaged. In particular, the working condition of the sagging damage in still water is most dangerous with a failure probability in order of 10^-2.
出处 《船舶》 2014年第5期46-49,共4页 Ship & Boat
关键词 剩余强度 可靠度 超大型油船 residual strength reliability VLCC
  • 相关文献

参考文献9

  • 1中国船级社.钢质海船人级规范[M].北京:人民交通出版社,2012.
  • 2祁恩荣,崔维成,彭兴宁,徐向东.船舶碰撞和搁浅后剩余强度可靠性评估[J].船舶力学,1999,3(5):40-46. 被引量:14
  • 3ABS Rules for Building and Classing Steel Vessel Rules [ S ] . Houston: [ s.n. ], 2013.
  • 4DNV Rules for Classification of Ships [ S ] .Norway :[ s.n. ], 2013.
  • 5Harmonised Common Structural Rules [ S ] .London :[ s.n. ], 2013.
  • 6The International Convention for the Prevention of Pollution From Ships [ S ] . [ S.1. ]: [ s.n. ], 1973.
  • 7Hussein A W, Soares C G. Reliability and residual strength of double hull tankers designed according to the new IACS common structural rules [ J ] . Ocean Engineering, 2009 ( 17 ) : 1446-1459.
  • 8舒鑫,吴剑国,洪英.破损船体的剩余极限强度分析[J].造船技术,2012,40(1):16-19. 被引量:1
  • 9伍友军,王晓宇.某双壳油船总纵极限强度计算与分析[J].船舶,2013,24(5):17-20. 被引量:1

二级参考文献12

  • 1崔维成.数值模拟法在结构可靠性分析中的应用[J].舰船科学技术,1994(2):1-6. 被引量:7
  • 2祁恩荣 彭兴宁 等.破损船体非对称弯曲极限强度分析.首届国内船舶与海洋工程结构力学会议[M].江西九江,1999..
  • 3肖锋.基于CSR的船体梁极限强度与破损剩余强度研究[B].杭州:浙江工业大学,2010.
  • 4ABS. ABS Ruls for Building and Classing Steel Vessel [s].2009.
  • 5DNV. DNV Rules for Planning and Execution of Ma- rine Operation [S]. 1996.
  • 6散货船结构共同规范[S].中国船级社.2009.
  • 7Ge Wang, Yongjun Chen. Longitudinal strength of ships with accidental damages[J]. Marine Structures, 15(2002) : 119-138.
  • 8任慧龙,冯国庆,李辉.超大型集装箱船极限强度评估方法研究报告[R].哈尔滨工程大学,2008.
  • 9胡毓仁,孙久龙.船体总纵极限弯矩简化方法计算方法研究及程序开发[R].上海交通大学,1999.
  • 10MSC.Nastran有限元分析理论基础与应用[M].北京:科学出版社,2004.

共引文献15

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部