摘要
In this study, a powder mixture with an Al/TiO2 molar ratio of 10/3 was used to form an r-Al2Ti intermetallic matrix composite （IMC） reinforced with α-Al2O3 ceramic by a novel milling technique, called discontinuous mechanical milling （DMM） instead of milling and ignition of the produced thermite. The results of energy dispersive X-ray spectroscopy （EDX） and X-ray diffraction （XRD） of samples with varying milling time indicate that this fabrication process requires considerable mechanical energy. It is shown that Al2Ti-α-Al2O3 IMC with small grain size was produced by DMM after 15 h of ball milling. Peaks for γ-TLA1 as well as Al2Ti and Al2O3 are observed in XRD patterns after DMM followed by heat treatment. The microhardness of the DMM-treated composite produced after heat treatment was higher than Hv 700.
In this study, a powder mixture with an Al/TiO2 molar ratio of 10/3 was used to form an r-Al2Ti intermetallic matrix composite （IMC） reinforced with α-Al2O3 ceramic by a novel milling technique, called discontinuous mechanical milling （DMM） instead of milling and ignition of the produced thermite. The results of energy dispersive X-ray spectroscopy （EDX） and X-ray diffraction （XRD） of samples with varying milling time indicate that this fabrication process requires considerable mechanical energy. It is shown that Al2Ti-α-Al2O3 IMC with small grain size was produced by DMM after 15 h of ball milling. Peaks for γ-TLA1 as well as Al2Ti and Al2O3 are observed in XRD patterns after DMM followed by heat treatment. The microhardness of the DMM-treated composite produced after heat treatment was higher than Hv 700.
