期刊文献+

气液同轴双离心式喷嘴喷雾特性 被引量:7

Spray characteristic of gas-liquid double swirl coaxial injector
下载PDF
导出
摘要 采用流体体积方法分析涡流器离心式喷嘴内部流动过程,采用单反相机和相位多普勒测速仪测量离心式喷嘴、气液同轴双离心式喷嘴的喷雾特性。发现涡流器离心式喷嘴内部流动的总压损失主要发生在涡流器槽道入口、收敛段和等直段。等直段使液膜厚度减小,喷雾锥角减小。离心式喷嘴喷雾粒径分布范围沿径向逐渐增加,轴向速度分布范围沿径向先减小后逐渐增加。气液同轴双离心式喷嘴喷雾特性受气液比影响很大,气液比小时旋流空气使喷雾锥角增加,粒径分布范围减小;气液比大时,气体膨胀压缩喷雾,使大液滴能够到达喷雾中心,喷雾外侧为二次雾化成的细小液滴。 The volume of fluid method was used to analyze the flow process in pressure swirl injector.SLR camera and phase doppler anemometry were used to measure the spray characteristics of swirl injector and gas-liquid double swirl coaxial injector.Results show that the total pressure loss occurs mainly in inlet section,convergent section,and columned section of swirler trough.The longer the columned section is,the thicker the liquid film and the smaller the spray cone angle is.The range of spay particle distribution increases gradually along the radial direction while the axial velocity distribution decreases firstly and then increases along radial direction.Spray characteristic of gas-liquid double swirl coaxial injector is greatly influenced by gas-liquid ratio (GLR).While GLR is small enough,swirling air increases the spray cone angle and decreases the range of particle distribution;while GLR is large enough,the expansion of air compresses the spray,pushing large droplets to the center of the spray.And at the edge of spray locates small droplets from second atomization.
出处 《国防科技大学学报》 EI CAS CSCD 北大核心 2014年第5期50-57,共8页 Journal of National University of Defense Technology
基金 国家自然科学基金资助项目(11472303 11402298) 新世纪优秀人才支持计划(NCET-13-0156)
关键词 气液同轴式喷嘴 双离心 喷雾特性 gas-liquid coaxial injector double swirl spray characteristic
  • 相关文献

参考文献21

  • 1刘娟,孙明波,李清廉,王振国.基于VOF方法分析离心式喷嘴结构参数对性能影响[J].航空动力学报,2011,26(12):2826-2833. 被引量:26
  • 2刘娟,李清廉,王振国,吴海燕.基于VOF方法模拟离心式喷嘴内部流动过程[J].航空动力学报,2011,26(9):1986-1994. 被引量:22
  • 3刘娟,李清廉,刘卫东,王振国.离心式喷嘴液膜破碎过程实验[J].推进技术,2011,32(4):539-543. 被引量:17
  • 4Yang L J, Fu Q F, Qu Y Y, et al. Spray characteristics ofgelled propellants in swirl injectors [ J ]. Fuel, 2012, 97:253 -261.
  • 5Rashid M S F M,Hamid AHA, Sheng 0 C,et al. Effect ofinlet slot number on the spray cone angle and dischargecoefficient of swirl atomizer[ J] ? Procedia Engineering, 2012,41:1781 -1786.
  • 6Kim S,Khil T, Kim D, et al. Effect of geometric parameterson the liquid film thickness and air core formation in a swirlinjector[J]. Measurement Science and Technology, 2009, 20(1):1-11.
  • 7王国辉,蔡体敏,何国强,胡春波.一种旋流式喷嘴的实验和数值研究[J].推进技术,2003,24(1):28-32. 被引量:40
  • 8Moon S, Abo-Serie E,Bae C. Liquid film thickness inside thehigh pressure swirl injectors : real scale measurement andevaluation of analytical equations [ J ]. Experimental Thermaland Fluid Science, 2010, 34(2) :113 -121.
  • 9Hamid AHA, Atan R. Spray characteristics of jet-swirlnozzles for thrust chamber injector[ J]. Aerospace Science andTechnology, 2009,13(4 -5) :192 -196.
  • 10苏中髙,甘晓华,王宏明,等.离心式及其气动辅助雾化喷嘴试验研究[C]//中国工程热物理学会2004年学术会议论文集,2004:613 -622.

二级参考文献71

共引文献163

同被引文献47

引证文献7

二级引证文献28

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部