期刊文献+

聚酯材料表面化学镀镍的研究

Research on Electroless Nickel Plating on Surface of Polyester Material
下载PDF
导出
摘要 研究了聚酯材料表面化学镀镍的实验操作方法、工艺控制条件,讨论了各种因素对镀层质量的影响,确定了聚酯材料表面化学镀镍的工艺流程和最佳实验条件。实验结果表明,聚酯材料经过预处理及敏化、活化处理后,化学镀镍溶液的p H值控制在5.5,镀镍温度在45℃,反应时间25min,可以得到较好的聚酯材料化学镀镍镀层。 The operating methods and condition of electroless nickel plating on surface of the polyester material were studied,influ-ence factors of nickel-plating on the surface of the polyester material were discussed.Then the combination strength between chemi-cal coating and polyester material was tested,the best process and optimum conditons were finally determined. The results showed that the optimum conditions were as followed:pH=5.5,the nickel plating temperature 45℃and the reaction time 10~20min. Under the above conditions,good nickel-plating coating on surface polyester material after pretreatment,sensitization and activation could be gained.
作者 刘建升
出处 《化工技术与开发》 CAS 2014年第12期22-25,共4页 Technology & Development of Chemical Industry
关键词 聚酯材料 化学镀 敏化 活化 polyester material electroless nickle plating sensitization activation
  • 相关文献

参考文献9

二级参考文献69

共引文献73

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部