期刊文献+

TBPB/TBPO引发不饱和聚酯树脂固化动力学研究 被引量:1

Study on the curing kinetics of unsaturated polyester resin initiated with TBPB /TBPO
原文传递
导出
摘要 采用非等温DSC法研究了过氧化苯甲酸叔丁酯(TBPB)/过氧化辛酸酯(TBPO)引发不饱和聚酯体系的固化行为以及TBPO含量对固化反应温度的影响。通过Kissinger和Ozawa方程计算得到固化反应的表观活化能。研究表明,随着TBPO含量增加,固化反应温度降低。TBPO的质量分数从0增加到40%时,Kissinger方程得到的活化能从4.4 kJ/mol降为2.3 kJ/mol,Ozawa方程的结果与之趋势一致。 The curing behavior of unsaturated polyester resin initiated with t- butyl peroxybenzoate( TBPB) /dicaprylate peroxide( TBPO) and the effect of TBPO content on the curing temperature were investigated by non- isothermal DSC. The apparent activation energy was calculated by Kissinger and Ozawa equations. The results showed that the curing reaction temperature was decreased with the increasing of TBPO content. The activation energy obtained by Kissinger equation was decreased from 4. 4 kJ /mol to 2. 3 kJ /mol with the TBPO content increasing from0 to 40wt% and the result of Ozawa equation was consistent with it.
出处 《热固性树脂》 CAS CSCD 北大核心 2014年第4期16-18,22,共4页 Thermosetting Resin
关键词 不饱和聚酯树脂 过氧化苯甲酸叔丁酯 过氧化辛酸酯 复合引发剂 固化动力学 unsaturated polyester resin tert-butyl peroxide peroxide caprylate composite initiator curing kinetics
  • 相关文献

参考文献5

  • 1Oh H,Park Y K,Ko Y.Effects of dual initiators and catalytic additives on atom transfer radical polymerization of styrene[J].Research on Chemical Intermediates,2011,37(9):1257-1265.
  • 2Gao J G,Huo L,Du Y G.Nonisothermal cure kinetics and diffusion effect of liquid-crystalline epoxy sulfonyl bis(1,4-phenylene)bis4-(2,3-epoxypropyloxy)benzoate resin with aromatic diamine[J].Journal of Applied Polymer Science,2012,125(5):3329-3334.
  • 3Manthey N W,Cardona F,Aravinthan T.Cure kinetic study of epoxidized hemp oil cured with a multiple catalytic system[J].Journal of Applied Polymer Science,2012,125(S2):511-517.
  • 4Liu S H,Lin C P,Shu C M.Thermokinetic parameters and thermal hazard evaluation for three organic peroxides by DSC and TAM III[J].Journal of Thermal Analysis and Calorimetry,2011,106(1):165-172.
  • 5Shojaei A,Farrahinia H,Pishvaie S M R.Effect of system of initiators on the process cycle of nonisothermal resin transfer moldingNumerical investigation[J].Composites Part a-Applied Science and Manufacturing,2010,41(1):.

同被引文献5

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部