1#复合压出线φ200供胶皮带控制系统改造

Improvement of φ200 rubber belt control system in 1# composite extruding line

原有1#复合压出线多处用到SEW直流电机,现在难以买到备件,为此将Φ200原SEW直流电机改为交流变频电机,将MENTORⅡ直流驱动器改为MITSUBISHI交流变频器。硬件上只是改变了电机和驱动装置,软件上更改了一段程序。改造后达到良好的效果,降低了成本。

the original1# composite extruding line use SEW DC motor in many palce,but it is hard to buy spare parts now. It will soon be change the SEW DC motor to AC frequency motor for φ200, change MENTOR II DC driver to MITSUBISHI AC driver. It is only changed the motor and drive device in hardware and a program in software. After modification, the system can achieved good effect and reduced the cost.