铝箔分卷机脱料机构的改造与仿真

Improvement and simulation on material removing mechanism of aluminum foil separator

针对原先铝箔分卷机脱料机构上存在的缺陷进行改造,由凸轮机构代替之前的气缸驱动,设计一种新型的脱料机构。在Pro/e环境下,对新型脱料机构的端面圆柱凸轮进行参数化设计,在Mechanism模块下对脱料机构进行运动仿真和测量结果验证,通过调整两凸轮的相对位置关系,缩短设计周期,并为后期的结构优化提供参考。

Structure of material removing mechanism was improved for the defects of original aluminum foil separator.In this structure transformation,the original cylinder drive is replaced by cam mechanism,forming a new type of material removing mechanism.In the Pro/e environment,surrounding and columniform cam of material removing mechanism conducted parametric design.In Mechanism module,through the motion simulation and measurement verification of material removing mechanism,the relative position of the two cams can be adjusted,ultimately reducing the design cycle and providing a reference for the structure optimization in the later period.