1[1]Kosmatka, John B, Hornbeck, et al. Overview of the Development of the ARPA/BIR Composite Assault Bridge [J]. International SAMPE Technical Conference, 1996, 28(4-en, 8): 1228-1239.
2[2]Lewit, Scott M, Jakubowski, et al. Low cost VARTM process for commercial and military applications [J]. International SAMPE Symposium and Exhibition (Proceedings), 1997, 42(2):1173-1187.
3[3]Pike T, McArthur M, Schade D. Vacuum assisted resin transfer molding of a layered structural laminate for application on ground combat vehicles [J]. International SAMPE Technical Conference, 1996, 28(4-7):374-380.
4[4]Elias J. Rigas, Shawn M. Walsh, William A. Spurgeon. Development of a novel processing technique for vacuum assisted resin transfer molding (VARTM) [A].In: SAMPLE [C]. 2001, 1086.
5[5]Andersson M, Lundstron S, Gebart B R,et al. Development of guidelines for the vacuum infusion process [A]. ln: Proceedings of FRP-2000 [C]. 2000.
6[6]Sun X D, Li S J, Lee L J. Mold filling analysis in vacuum-assisted resin transfer molding, Part Ⅰ: SCRIMP Based on High-Permeable Medium [J]. Polymer Composites, 1998,19(6):807-817.
7[7]Sun X D, Li S J, Lee L J. Mold filling analysis in vacuum-assisted resin transfer molding, Part Ⅱ: SCRIMP Based on High-Permeable Medium [J]. Plymer Composites, 1998,19(6):818-829.
8[8]Mathur R, Heider D, Hoffmann C, et al. Flow front measurements and model validation in the vacuum assisted resin transfer molding process [J]. Polym Compos, 2001,22(4):477-490.
9[9]Lacy G E, Eng P. Gall B B. Fabrication of a large FRP deck with longitudinal and transverse stiffeners in a single infusion [J]. Composites, 2000, 27-30:141-149.
10Sun X D, Li S J, Lee L J. Molding filling analysis in vacuum assistnt resin transfer molding. Polymer Composites,1998,19(6):807.
