基于物联网远程监测机房温湿度系统设计

Remote Monitoring System Design of Room Temperature and Humidity Based on Internet

机房内播出设备的正常运行是保障安全播出的重要因素,良好的温湿度可以充分的发挥设备的性能、延长设备的使用寿命、降低设备的故障率。而传统温湿度检测布线繁琐、工作量大、不能实时检测。本系统使用STC89C52单片机为核心,采用带A/D转换的温湿度传感器SHT10采集温湿度,将采集到的数据通过单片机计算处理后以Wi Fi(IEEE802.11标准)形式传输到Wi Fi局域网,再通过PC机上的监控软件集中显示实时温湿度等数据,很好的解决了传统检测的不足。

The normal operation of the broadcasting equipment in the engine room is the important factor of safety broadcast. Good performance of temperature and humidity can give full play of the equipment, prolong the service life of equipment, and reduce the failure rate of the equipment. The traditional temperature and humidity test is wiring trival, big workload, not real- time detection. STC89C52 single-chip microcomputer is used as the core, used temperature and humidity sensor SHT10 acqui- sition with A/D conversion. Data collected by single chip microcomputer to WiFi （IEEE802.11 standard） transmits the WiFi network form ,through the PC monitoring software concentrated display real-time temperature and humidity data, Which improves the deficiency of the traditional detection.