期刊文献+

水泥混凝土墙柔性造价与热应力梯度边界模拟

Numerical Simulation of Cement Concrete Wall Flexible and Thermal Stress Gradient Boundary
下载PDF
导出
摘要 我国的水泥混凝土墙面柔性小,对温度要求高。使用中因温度受热不均匀,各处膨胀变形或收缩变形不一致,导致墙面建材造价高,墙面坚硬程度低。为此,提出一种水泥混凝土墙面柔性造价与热应力梯度边界模拟数值分析,通过对水泥混凝土墙面的建材分析,墙面柔性的造价会比传统的墙面建材降低许多,相比于刚性墙面挡墙,柔性墙面加筋土挡墙,允许挡墙在施工和后期运营过程中墙体产生差异沉降,因此更适合于柔性墙面。仿真实验表明,水泥混凝土墙面柔性造价与热应力梯度边界模拟数值分析能够有效地提高墙面柔性,且造价减少隔音效果更加明显,抗震性能强。 Along with our country accelerate infrastructure construction, cement concrete has been widely used in decorating a examination. But cement concrete wall in the current use of the decrease of the metope of flexible and high temperature stress, the characteristics of metope varies depending on the frequency, the frequency from low to high, uneven heating temperature, expansion deformation or contraction inconsistent throughout, causes of metope is a building materials of high cost and hard degree reduced. For this, put forward the concrete wall and the cost of flexible thermal stress gradient boundary simulation numerical analysis, through the analysis of the building materials for cement concrete wall, metope, flexible than traditional wall materials reduced cost of many, compared with the rigid retaining wall metope, flexible wall reinforced soil retaining wall allows the retaining wall foundation produced in the process of construction and operation of larger differential settlement, therefore more suitable for the flexible wall. The simulation experiments show that the thermal stress of concrete walls and the cost of flexible gradient boundary simulation numerical analysis can effectively improve the metope of flexible.
作者 周炳梅
机构地区 贵州理工学院
出处 《科技通报》 北大核心 2015年第4期193-195,共3页 Bulletin of Science and Technology
关键词 水泥混凝土 热应力 墙面柔性 cement concrete the thermal stress wall flexible
  • 相关文献

参考文献7

  • 1高启聚,丛林,郭忠印.废弃水泥混凝土路面板在路面基层中的再生利用[J].公路交通科技,2008,25(2):20-23. 被引量:31
  • 2陈立,喻绍军,张强.旧水泥路面集料化再生利用于基层的效益分析[J].山西建筑,2009,35(35):255-256. 被引量:3
  • 3American.Association.of.State.Highway.and.Transporation Officials:Mechanistic-Empirical Pavement Design Guide[M].Interim.Edition:A.Manual.of.Practice.AASHTO,July2008.
  • 4Tanchaisawat T,Bergado DT,Voottipruex P.Numerical simulation and sensitivity analyses of full-scale test embankment with rein-forced lightweight geomaterials on soft Bangkok clay[J].Geotextiles and Geomembranes,2008.26:498-511.
  • 5刘华炜,刘学武,张广文.功能梯度材料制备工艺及研究进展[J].机械设计与制造,2012(4):265-267. 被引量:21
  • 6J G Yu.X M Zhang,T L Xue.Generalized the rmoe lastic waves in functionally graded plates without energy dissipation[J].Compos.Struct,2010,93(24):32-39.
  • 7S Sahraee,A R Saidi.Axisymmetric bending analysis of thick functionally graded circular plates using fourth-of=rder.shear.deformation.theory[J].Eur.J.Mech.A/Solids,2009,28(5):974-984.

二级参考文献21

  • 1邢世凯,李聚霞,吴立勋,卜荣凯.金属-陶瓷梯度功能材料在内燃机上的应用研究[J].机械工程材料,2005,29(5):61-63. 被引量:13
  • 2陈丽梅,李强.等离子喷涂技术现状及发展[J].热处理技术与装备,2006,27(1):1-5. 被引量:53
  • 3王军龙,肖建庄.二灰稳定再生集料的抗压强度研究[J].公路交通科技,2006,23(8):36-39. 被引量:11
  • 4常州市公路管理处.旧水泥混凝土板块在公路基层中再生利用的应用研究[R].2008.
  • 5JTJ058,公路工程集料试验规程[S].
  • 6JTGD50,公路沥青路面设计规范[S].
  • 7新野正之 乎井敏雄.渡边龙三倾斜机能材料-宇宙机用超耐热材料应用.日本复合材料学会志,1987,13(6):257-264.
  • 8U.Leushake,A.N.Winter. etal. General Aspects of FGM Fabrication by Powder Stacking. Materials Science Forum. Vol.308-311 (1999) : 13-18.
  • 9Rodriguez-Castro R, Kel Estemur M H.Processing and microstnmtural haracterization of functionally gradient A1 A359/SiCp composite [J]. lournal of Materials Science, 2002, 37(9) : 1813-1821.
  • 10Kaya Cengiz.A1203-Y-TZP/AI203 functionally graded composites of tubular shape fromnano-sols using double-step electrophoretic deposition[J].Journal of European Ceramic Society, 2003,23(10) : 1655- 1660.

共引文献52

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部