期刊文献+

1420铝锂合金电致超塑性本构方程 被引量:10

Constitutive equation of electro-superplastic for 1420 Al- Li alloy
原文传递
导出
摘要 变形温度为480℃时,对1420铝锂合金进行了不同应变速率、脉冲电流密度和脉冲频率的电致超塑性拉伸试验;通过对现有超塑性本构方程进行修正,建立了耦合脉冲电流密度和脉冲频率的超塑性本构方程,并对其进行了试验验证。研究结果表明:变形温度为480℃、应变速率为0.001 s-1时,在1420铝锂合金的超塑性拉伸试验中施加脉冲电流后,材料的流动应力比未施加电流时有所降低,伸长率有所增加;当脉冲电流密度为192 A·mm-2、脉冲频率为150 Hz时,材料的流动应力最小,伸长率最大。通过耦合脉冲电流参数的本构方程计算的流动应力值与试验数据吻合较好,能够准确预测1420铝锂合金在电致超塑性变形中流动应力的变化趋势。 The uniaxial tensile tests of electro-superplastic for 1420 Al -Li alloy were carried out with different parameters of strain rate, pulse current density and pulse frequency at the deformation temperature of 480 ℃. Through revising the current constitutive equations of superplastic, the constitutive equation of electro-superplastic for 1420 Al - Li alloy coupling with pulse current density and pulse frequency was established, and then the constitutive equation was validated by experimental data. The results show that, when the deformation tem- perature is 480 ℃ and the strain rate is 0. 001 s -1, the flow stress of alloy with uniaxial superplastic tensile tests of being added pulse cur- rent density is slightly lower than that without being added pulse current density, and the elongation of alloy increases a little. Meanwhile, when pulse current density is 192 A· mm-2and the pulse frequency is 150 Hz, the minimum flow stress and the maximum elongation of alloy are obtained. And the flow stress calculated by the constitutive equation coupling with pulse current parameters is close to the experimental data, and the change trend of flow stress during electro-superplastic forming for 1420 Al - Li alloy can be predicted accurately.
出处 《锻压技术》 CAS CSCD 北大核心 2015年第5期63-68,共6页 Forging & Stamping Technology
基金 国家自然科学基金资助项目(51334006 51405457) 国家重点基础研究发展计划资助项目(2011CB012803)
关键词 1420铝锂合金 电致超塑性 本构方程 脉冲电流 1420 Al-Li alloy electro-superplastic constitutive equation pulse current
  • 相关文献

参考文献14

二级参考文献103

共引文献164

同被引文献90

引证文献10

二级引证文献41

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部