期刊文献+

脱硫溶碱槽技改方案探讨

下载PDF
导出
摘要 针对脱硫溶硫房整个楼层的墙体出现较大裂缝的现象,分析产生裂缝的原因,提出解决问题的两种技术改造方案,通过的技改方案的对比,采取在容碱槽设备的支座处增加弹簧减振器的技术改造措施,取得了较好的技改效果。 For the desulfurization of sulfur dissolving real the entire floor of the wall appear larger crack phenomenon, cause analysis of cracracksin, putforward to solve the problem of two technical transformation scheme, through the technological transformation scheme comparison, take springshock absorberoftechnical transformation measures increase in alkatibath equipmentsupport, and achievedbetter technical effect
作者 陈华
出处 《科技风》 2015年第15期108-108,共1页
关键词 溶碱槽 技改 振动 减振器 alkali bath technological transformation vibration shock absorber
  • 相关文献

参考文献4

二级参考文献17

  • 1葛晓华,郭波,常丽萍.高温煤气脱硫剂的研究进展[J].工业催化,2005,13(11):6-11. 被引量:9
  • 2赵玺灵,张兴梅,段常贵,邹平华.SOFC分布式热电联供系统的性能研究[J].华北电力大学学报(自然科学版),2007,34(5):76-80. 被引量:9
  • 3倪维斗,李政,等.基于煤气化的多联产能源系统【M】.北京:清华大学出版社,2011.
  • 4J. Agnew, E. Hampartsoumian, J.M. Jones. The effect of sintering on sulphur capture by limestone and dolomite[J]. Journal of the Energy Institute, 2005 (78): 81-89.
  • 5Schilling H D, Bonn B. Krauss U. Coal gasification Verlag gluckauf gmbH: Essen [J]. Federal Republic of Germany, 1979: 71.
  • 6Pineda M, Palacios J M, Alonso L. Performance of zinc oxide based sorbents for hot coal gas desulfurization in multi-cycle tests in a fixed bed reactor [J]. Fuel, 2000 (79): 885-895.
  • 7Liu K, Song C S, Subramani V. Hydrogen and syngas production and purification technologies [P]. John Wiley & Sons, Incorpo, 2009, USA: 9780471719755.
  • 8Aravind P V, Ouwehjes J P, Woudstra N. Impact of biomass-derived contaminants on SOFCs with Ni/Gadolinia-doped ceria anodes [J]. Electrochemical and Solid-State Lette~, 2008 (11) : 24 - 28.
  • 9Xiangmei Meng, Wiebren de Jong, Ranadeep Pal, et al. In bed and downstream hot gas desulphurization during solid fuel gasifiction: A review [J]. Fuel Processing Technology, 2010, 91:964-981.
  • 10Westmoreland, Harrison. Evaluation of candidate solids for high- temperature desulfurization of Low-Btu Gases, Environmental Science & Technology, 1976, 10(7): 659-661.

共引文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部