期刊文献+

三维环绕追踪式RFID识别系统的研究 被引量:1

ON 3-D SURROUNDED TRACKING TYPE RFID SYSTEM
下载PDF
导出
摘要 由于货物自身的遮挡和工作现场的各种干扰,多个RFID标签同时进行识别时存在很高的漏读率,影响了RFID系统的可靠性。针对这一问题,提出了三维环绕追踪式RFID识别系统。采用四个阅读天线两两相对,以三维立体的方式安装在阅读通道形成一个天线门。在货物从阅读区域的入口移动到出口的整个过程中进行连续追踪式的环绕读取,最大限度减少因遮挡而形成的识别盲点,增大信号覆盖范围,从而降低RFID标签漏读率。同时建立了基于三维天线的追踪识别控制流程。实验结果表明:三维环绕追踪式RFID识别系统对降低多个RFID标签集中识别的漏读率有明显的效果,为RFID识别系统在高速物流领域的商用提供了新的方法。 Due to occluding by the goods themselves and various kinds of interference on work site,there is very high missing-read rate when multiple RFID tags are identified at the same time,which affects the reliability of the RFID system.Aiming at this issue,the paper puts forward an RFID system in three-dimensional surrounded tracking type.It is composed of four reading antennas in pair each other,and mounted in reading channel in 3-dimensional way to form an antennas gate.During the whole process of the goods moving in reading area from entrance to exits,continuous tracking surround reading will be carried out,this reduces the identification blind spots incurred by occlusion to the maximum extent,and enlarges the signal coverage range,thereby reduces the missing-read rate on RFID tags.Meanwhile,the tracing and identification control process based on three-dimensional antenna is established.Experimental results indicate that:the RFID system in three-dimensional surrounded tracking type has significant effect on reducing the missing-reading rate of concentrated identification of multiple RFID tags,which provides a new method for RFID system in commercial application in high speed logistics sector.
出处 《计算机应用与软件》 CSCD 2015年第10期90-94,共5页 Computer Applications and Software
基金 上海市科学技术委员会应用技术开发专项项目(2012-109)
关键词 环绕追踪 三维天线 射频识别 漏读率 可靠性分析 多标签识别 Surrounded tracking Three-dimensional antenna RFID Missing-read rate Reliability analysis Multiple-label identification
  • 相关文献

参考文献2

二级参考文献8

  • 1余开.无源超高频射频识别系统链路性能分析与测量[D].长沙:湖南大学电气与信息学院,2012.
  • 2Mi M, et al. RF energy harvesting with multiple antennas in the same space. Antennas and Propagation Magazine [J], IEEE, 2005. 47 (5): p. 100--106.
  • 3Angerer C. Maximal ratio combining receivers for dual antenna RFID readers [A]. Wireless Sensing, Local Positioning, and RFID, 2009. MTT- S International Microwave Workshop on IEEE [C]. 2009.
  • 4Langwieser R, Angerer C, Scholtz A L. A Testbed for Multi--An- tenna Applications in RFID [C]. Berlin, RadioTecC 2009.
  • 5Griffin, J. D. and G. D. Durgin, Gains or RF tags using multiple antennas [J]. Antennas and Propagation, IEEE Transactions on, 2008. 56 (2): p. 563--570.
  • 6Kim, D. Y. , et al. , Reverse--Link Interrogation Range o{ a UHF MIMO--RFID System in Nakagami--m Fading Channels. Industrial Electronics [J], IEEE Transactions on, 2010. 57 (4): p. 1468 --1477.
  • 7ISO, ISO/IEC 18000--6 Part 6 Parameters for air interface com- munications at 860 MHz to 960 MHz, in Information technology -- Radio frequency identification for item management --2010 [Z]. ISO copyright office: Switzerland.
  • 8信息产业部.关于发布800/900MHz频段射频识别(RFID)技术应用试行规定的通知[Z].信息产业部,2007.

共引文献4

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部