期刊文献+

200MW高温气冷堆汽轮机热力系统能损分析

Energy Loss Analysis of Turbine in 200MW High Temperature Gas Cooled Reactor Nuclear Power Plant
下载PDF
导出
摘要 采用能级效率法对200MW高温气冷堆核电机组的热力系统能损分析,特别是对各级加热器的能损进行了解耦分析。通过引入加热器的热耗影响因数,获得了VWO、TRL、75%TRL、50%TRL 4种工况下各级加热器对降低热力系统热耗的影响和变化规律。以上分析方法和结果,可以为200MW高温气冷堆核电机组的热力系统的设计、优化、运行和维护提供重要参考。 In this paper, energy loss analysis of thermal power system of 200MW high temperature gas cooled reactor nuclear power plant with the energy level efficiency method, especially for the energy loss deeoupling analysis of each heater. By introducing the heat consumption influence coefficient, the influence of each heater in reducing the heat consumption of thermodynamic system under the conditions of VWO,TRL,75% otTRL and 50% otTRL was obtained. The above results provide important reference for the design, optimization, operation and maintenance of the thermal system of 200MW high temperature gas cooled reactor nuclear power plant.
作者 杨宇
出处 《汽轮机技术》 北大核心 2015年第6期405-408,共4页 Turbine Technology
基金 国家核电技术公司员工自主创新项目(SNP-KJ-CX-2015-20)
关键词 热力系统 热耗 能级效率 加热器 thermodynamic system heat consumption energy level efficiency heater
  • 相关文献

参考文献3

二级参考文献8

  • 1闫水保,闫留保.电厂热力系统节能分析原理及应用[M].郑州:黄河水利出版社,2000.
  • 2Blum R, Kjaer S, Bugge J. Development of a PF fired high efficiency power plant (ADT00) [C]//Proceedings of the Riso International Energy Conference " Energy Solutions for Sustainable Development". Riso R 1608 (EN),Denmark, 2007.
  • 3Bugge J, Kjaer S, Blum R. High-efficiency coal-fired power plants development and prespectives[J]. Ener- gy,2006,31(10) : 1437-1445.
  • 4Kjaer S, Drinhaus F. A modified double reheat cycle [C]//ASME 2010 Power Conference. American Socie- ty of Mechanical Engineers, 2010 : 285-293.
  • 5Ploumen P, Stienstra G, Kamphuis H. Reduction of CO2 emissions of coal fired power plants by optimizing steam water cycle [J]. Energy Proeedia, 2011, 4: 2074-2081.
  • 6杨宇,史进渊,邓志成,汪勇.基于能级效率法的1000MW汽轮机热耗计算分析[J].发电设备,2011,25(1):5-8. 被引量:8
  • 7阚伟民,宋景慧,周璐瑶,赵世飞,徐钢.超超临界机组采用MC系统的变工况性能研究[J].热力发电,2014,43(7):41-44. 被引量:14
  • 8杨宇.汽轮机转子温度计算中惯性环节系数的确定方法[J].动力工程学报,2014,34(5):361-364. 被引量:3

共引文献18

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部