期刊文献+

光纤激光熔覆铁基合金粉末对45钢表面组织和性能的影响 被引量:8

Effects of Fiber Laser Cladding Fe-based Alloy Powder on Microstructure and Properties of 45 Steel Surface
下载PDF
导出
摘要 利用IPG-3000W光纤连续激光器和激光同轴送粉方式在45钢表面熔覆铁基合金粉末,利用金相显微镜、显微硬度计、X射线衍射仪等,分析研究激光熔覆铁基合金粉末对45钢微观组织、显微硬度的影响。结果表明:45钢光纤激光熔覆层的微观组织为胞状晶、柱状品、树枝晶和等轴晶,主要物相为Ni-Cr-Fe、γ-[Fe,Ni];当激光功率为600W,扫描速度为0.3m/s,送粉速率为0.8g/h,靠近结合面一侧的熔覆层处最大硬度值为560HV。对比单道和多道搭接熔覆层硬度。 Fe-based alloy powder coating was prepared on the surface of 45 steel by using fiber laser IPG-3000W and laser coaxial feeding powder technology. The effects of Fe-based alloy powder coating on micro-structure and micro-hardness were studied by using metallographic microscope, micro-hardness tester and X-ray diffraction. The results show that the microstructure of the laser cladding layer are cellular crystal, columnar crystal, dendrite and equiaxed crystal. The phases are composed of Ni-Cr-Fe and γ-[Fe,Ni]. The maximum hardness appears at the cladding layer near the bonding zone and the value reaches 560 HV when the laser power is 600W, the scanning rate is 0.3 m/s and the feeding rate is 0.8 g/s. By comparing the single laser cladding and the overlapping laser cladding, it is found that the hardness of the overlapping laser cladding layer is higher about 40-50 HV than the single laser cladding layer.
出处 《铸造技术》 CAS 北大核心 2016年第1期44-47,共4页 Foundry Technology
基金 辽宁省自然科学基金(2013020086) 2013中央支持地方高校发展专项基金(汽车零部件先进制造技术协同创新团队项目)资助
关键词 激光熔覆 显微硬度 微观组织 搭接熔覆层 laser cladding micro-hardness microstructure overlapping laser cladding layer
  • 相关文献

参考文献9

二级参考文献67

共引文献226

同被引文献50

引证文献8

二级引证文献25

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部