期刊文献+

基于不同铣削方式的球头铣刀切削性能的研究 被引量:1

Research of ball end mill cutting property based on the different ways of milling
下载PDF
导出
摘要 利用Third Wave Advant Edge软件针对球头铣刀的平面和斜面铣削建立铣削模型,采用单因素的方法对球头铣刀铣削7075-T6进行有限元仿真试验,得到铣削力和铣削温度在不同铣削方式下随转速、进给量及切削深度变化的规律,为球头铣刀铣削7075-T6的铣削方式和铣削参数的合理选择提供依据。 Milling model for ball end mill plane and cant milling is built by using the Third Wave of AdvantEdge software. The method of single factor is used to carry out Finite element simulation test of milling 7075-T6 using the ball end mill. The milling force and milling temperature under different milling method on speed, feed and cutting depth change rule is got. It will provide the basis for ball end milling cutter with 7075 - T6 milling method and reasonable selection of milling parameters.
出处 《机械》 2016年第1期4-7,共4页 Machinery
基金 国家自然科学基金(51265005)
关键词 THIRD WAVE AdvantEdge 球头铣刀 有限元仿真 Third Wave Advantedge ball end mill finite element simulation
  • 相关文献

参考文献8

二级参考文献35

共引文献33

同被引文献2

引证文献1

二级引证文献5

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部