摘要
TS2130深孔钻镗床主轴卡盘、辅助卡盘距离大,无法加工出长度小于2m的工件;文中提供新工装方法:将工件冒口端装夹在主轴卡盘上,锭尾端装夹在中心架上;将工件找正;对工件进行深孔加工。通过改进工装,使深孔加工短节产品达到了技术要求,填补了公司加工2m以下短节产品深孔加工的空白。
The distance between spindle chuck and the rear chuck of TS2130 deep hole drilling and boring machine is large,so it is difficult to process the axle whose length was shorter than 2m. This paper improves the clamping method. The riser is clamped on the spindle chuck, and spindle end is clamped on center frame, the workpiece is centered, the workpiece is deep hole machined. The improved tooling could process short deep-hole workpiece.
出处
《机械工程师》
2016年第2期122-123,共2页
Mechanical Engineer
关键词
深孔加工
卡盘
中心架
deep-hole machining
cartridge
centre frame
